交换机_路由器配置与管理 作者 桑世庆 卢晓慧 项目二、Cisco IOS的用户配置.pptVIP

Subnet mask for this interface [] : //配置该接口的子网掩码。(默认为,可以手工输入修改) Class C network is , 24 subnet bits; mask is /24 Do you want to configure Serial0/0 interface? [yes]: y //您想配置Serial0/0接口吗?选Y Some supported encapsulations are ppp/hdlc/frame-relay/lapb/x25/atm-dxi/smds Choose encapsulation type [hdlc]: //选择封装方式(默认的封装方式是HDLC) No serial cable seen. Choose mode from (dce/dte) [dte]: //因为没有连串口线，所以会让您选择设备类型 Configure IP on this interface? [yes]: y //在接口上配置IP Configure IP unnumbered on this interface? [no]: IP address for this interface: //配置该接口的IP地址 Subnet mask for this interface [] : 52 //配置该接口的子网掩码。(默认为,可以手工输入修改为52) Class B network is , 30 subnet bits; mask is /30 //以下配置同上 Do you want to configure FastEthernet0/1 interface? [yes]: Use the 100 Base-TX (RJ-45) connector? [yes]: Operate in full-duplex mode? [no]: y Configure IP on this interface? [yes]: y IP address for this interface: Subnet mask for this interface [] : 52 Class B network is , 30 subnet bits; mask is /30 The following configuration command script was created: //把您的配置显示出来 … //以下提示您是否保存这次设置 [0] Go to the IOS command prompt without saving this config. [1] Return back to the setup without saving this config. [2] Save this configuration to nvram and exit. Enter your selection [2]: 2 　//选择2保存设置，并存入NVRAM中 Building configuration... [OK] Use the enabled mode configure command to modify this configuration. Press RETURN to get started! //路由器重新启动 00:00:08: %LINK-3-UPDOWN: Interface Serial0/0, changed state to down 00:00:08: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up 00:00:08: %LINK-3-UPDOWN: Interface FastEthernet0/1, changed state to up 00:00:09: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to down 00:03:18: %IP-5-WEBINST_KILL: Terminating DNS process 00:03:24: %SYS-5-RESTART: System restarted -- Cisco Internetwork Operating System Software IOS (tm) 3600 Software (C3640-I-M), Version 12.1(2)T, RELEASE SOFTWARE (fc1) Copyr