模具专业英语 王浩钢 14456第3章新.pptVIP

Lesson 3  Basic Underfeed Mould 　　 A simple mould of this type is shown in Figure 3-1, and a description of the design and of the opening sequence follows. The mould consists of three basic parts, namely: the moving half, the floating cavity plate and the feed plate, respectively. 　　The moving half consists of the moving mould plate assembly, support blocks, backing plate, ejector assembly and the pin ejection system. Thus the moving half in this design is identical with the moving half of basic moulds. 　　The floating cavity plate, which may be of the integer or insert-bolster design, is l