Q1PutTfortrueorFforfalseinfrontofthefollowing.docVIP

Q1: Put T for true or F for false in front of the following statements: --------------- 2. The element of the grinding machine that provides the cross movement to the work piece is the wheel head --------------- 3. As the temperature of cutting tool increases, the hardness of the cutting tool will increase also --------------- 4. The operation that is suffering from cycling of impact and thermal shock on every rotation is grinding --------------- 5. The type of wood that comes in three layers from the same type with crossing fibers and it is used for low stress applications is the block board --------------- 6. As an example of tree wood that belongs to hard wood is the Cedar Wood --------------- 7. The type of wear that occurs suddenly (catastrophic) in turning operation is known as built up edge. --------------- 8. One of the four operations, i. e. milling, grinding, drilling and shaping can be performed on a lthe. This operation is the drilling. --------------- 9. An example of an operation that uses single- point cutting edge tool is slotting --------------- 10. A suitable way to hold a work piece in a vertical milling machine is by using the spindle --------------- 11. Machining is the manufacturing process in which the size, shape, or surface properties of a part are changing by removing the excess material --------------- 12. The electrical connection at home is in parallel when it uses single phase and in series when it uses two phases. Q2: Complete the following statements 1. For machining, the substances that is consider excellent coolant and poor lubricant is --------------- 2. The highest number of cutting tool edges among milling cutters, chisel, grinding wheel and saw exists in --------------- 3. What causes temperature to increase in turning operation is an increase in velocity, a decrease in depth of cut, an increase in feed rate and a decrease in --------------- 4. One reason for using cutting fluid in machining is to protect