SB13-Synventive.PDFVIP

Hot Sprue Bushings Products/Technical Guide SB13 Hot Sprue Bushings 22Notes Ideal for High Capacity Molding 1. Cold bushing length must Synventive SB13 hot sprue bushings are specifically designed for use where high capacity, high quality allow for thermal expan- melt transfer is necessary. These bushings are ideally suited for all combinations of large shot and/or sion to fit specified mold viscous materials. length. Allow .003 x (A) for thermal expansion of Each SB13 bushing is supplied with a 50mm machining allowance to adjust the bushing to desired bushing. When machining mold depth. bushing “A” length for CV- 10, 11 21 tips, bushing All bushings come complete with replaceable hard radius seat, mineral insulated heater band and ther- “A” (cold) = “A” (mold) x mocouple hole. A .500, .750 or metric radius is provided per your specification. .997. When machining bushing “A” length for CV- Specifications 20 tips, bushing “A” cold Max. Operating Pressure: 20,000 psi (1400 bar) = (“A” mold - 2.5) x .997. Max. Operating Temperature: 650°F (345°C) 2. When using with stripper Mode of Operation: Horizontal plate mold, moldmaker Heater: 50 x 50mm should machine a stripper 750 W, 120 or 240 V sleeve (see Technical Heater Clearance Diameter: 89mm Guide “Section F”). This stripper sleeve is not provided by Synventive for SB13 bushings. 3. All dimensions are in mm. MM 4. 420 SS bushings are “A” min. 26 available on special order “A” max. 226 for processing PVC or “D1” 26h6 other corrosive materials. “D2” 50