GraniteSpec040927.doc-BoomsStoneCo.docVIP

GRANITE 1.0 GENERAL 1.1 Related Documents Drawings and general provisions, including General and Supplementary Conditions of the Contract and Division I Specification sections, apply to this section. 1.2 Applicable Publications The following publications listed here and referred to thereafter by alphanumeric code designation only, form a part of this specification to the extent indicated by the references thereto: 1) ASTM International (ASTM): C615-99 Standard Specification for Granite Dimension Stone A666-00 Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar B221-00 Standard Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes C97-02 Standard Test Methods for Absorption and Bulk Specific Gravity of Dimension Stone C99-87(2000) Standard Test Method for Modulus of Rupture of Dimension Stone C119-03 Standard Terminology Relating to Dimension Stone C170-90(1999) Standard Test Method for Compressive Strength of Dimension Stone C241-90(1997)e1 Standard Test Method for Abrasion Resistance of Stone Subjected to Foot Traffic C270-03 Standard Specification for Mortar for Unit Masonry C295-03 Standard Guide for Petrographic Examination of Aggregates for Concrete C880-98 Standard Test Method for Flexural Strength of Dimension Stone C1028-96 Standard Test Method for Determining the Static Coefficient of Friction of Ceramic Tile and Other Like Surfaces by the Horizontal Dynamometer Pull-Meter Method C1201-91(1996) Standard Test Method for Structural Performance of Exterior Dimension Stone Cladding Systems by Uniform Static Air Pressure Difference C1242-02a Standard Guide for Selection, Design, and Installation of Exterior Dimension Stone Anchors and Anchoring Systems C1352-96(2002) Standard Test Method for Flexural Modulus of Elasticity of Dimension Stone C1353-98e1 Standard Test Method Using the Taber Abraser for Abrasion Resistance of Dimension Stone Subjected to Foot Traffic C