JointerPPT.pptVIP

Jointer General Safety Wear your safety glasses at all times Take off all jewelry Do not wear loose clothing Make sure you are the only person in the safety zone when operating the jointer. General Safety continued Never set material on the tables of the jointer Never stand directly behind the machine Always joint material with the grain Never joint the end grain of material The operator should always do the jointing operation himself/herself The operator should never pass his/her hands over the cutter head. Components of the Jointer Fence Fence Tilt Control Fence Width Control Guard In-feed Table Out-feed Table Components of the Jointer In-feed Table Adjustment Wheel Depth Scale Push Platen Operations of the Jointer Face Plane Edge Plane Fence Fence Tilt Control Fence Width Control Guard In-feed Table Out-feed Table In-feed Table Adjustment Wheel Depth Scale Push Platen Face Plane Face Plane is defined as cutting a thin layer off one face of the material Edge Plane Edge Plane is defined as cutting a thin layer off one edge of the material Operation Procedure 1 1. When creating a face plane make sure the cupped side is down to ensure the material has two contact points on the table Operation Procedure 2 2. Adjust the in-feed table to the preferred depth of cut. AND The MAXIMUM safe cut on the jointer when jointing the face of the material is 1/16 of an inch. Operation Procedure 3 3. Stock less than 11” must not be run through the jointer AND Set the push platen on top of the material making sure the heel of the platen catches the end of the material. AND Turn the machine on. Operation Procedure 4 4. Manually move the guard, and let it rest on the edge of your material before you feed it into the cutterhead. Operation Procedure 5 5. Keep both hands on the push platen as you slowly slide the material through the cutterhead. Slide the material across the table until the guard retracts against the fence. Cupped side down Depth Adjustment H