superpressure-NewportScientific,Inc.docVIP

admin\manual\formtool OCTOBER 1992 SUPERPRESSURE INSTRUCTION 809-F HIGH-PRESSURE TUBING PREPARATION and CONE-TYPE AND LENS RING CONNECTIONS for 1/4, 3/8, and 9/16-inch TUBING and 9/16-inch HIGH-FLOW TUBING PART NO. 48-15013 48-15025 48-15033 48-15045 48-15063 48-15075 NEWPORT SCIENTIFIC, INC. (formerly AMINCO) 8246-E SANDY COURT JESSUP, MD 20794 (301) 498-6700 FAX (301) 490-2313  CONTENTS I INSPECTION - - - - - - - - - - - - - - - - - - - - - - - - 1 II DESCRIPTION - - - - - - - - - - - - - - - - - - - - - - - 1 III OPERATION OF FORMING TOOL - - - - - - - - - - - - - - - - 2 IV ASSEMBLY OF THREADING TOOL - - - - - - - - - - - - - - - - 3 V THREADING PROCEDURE - - - - - - - - - - - - - - - - - - - 5 VI PREPARING INNER-DIAMETER RECESS for HIGH FLOW LENS-RING CONNECTIONS - - - - - - - - - - - - - - - - - - 6 VII MAINTENANCE - - - - - - - - - - - - - - - - - - - - - - - 7 VIII PARTS INDEX - - - - - - - - - - - - - - - - - - - - - - - 7 FIGURES FIGURE 1. FORMING TOOL - - - - - - - - - - - - - - - - - - 1 FIGURE 2. THREADING TOOL - - - - - - - - - - - - - - - - - 1 FIGURE 3. FORMING TOOL PARTS LIST - - - - - - - - - - - - 2 FIGURE 4. THREADING TOOL PARTS LIST - - - - - - - - - - - 4 FIGURE 5. SUPERPRESSURE TUBE-END DIMENSIONS - - - - - - - 5 FIGURE 6. HIGH-FLOW FORMING TOOL - - - - - - - - - - - - - 6 FIGURE 7. HIGH-FLOW TUBE END DIMENSIONS - - - - - - - - - 9 I INSPECTION If damage is discovered upon unpacking equipment, an immediate request should be forwarded to the delivering carrier to perform an inspection and prepare a concealed-damage report. Concurrently, the nature and extent of damage should be reported to Newport Scientific, Inc., giving unit serial and catalog numbers, so that action may be initiated to repair or replace damaged parts or instructions issued of the apparatus if such is necessary. II DESCRIPTION A. It is fr