TheLadderDiagram-PurdueUniversityCalumet.docVIP

ADVANCED PROGRAMMABLE LOGIC CONTROLLER Reading and Interpreting Ladder Diagrams Ladder Diagram #1: Please review the following and answer the questions below. Assumptions: I:001/01 is a normally open start button and I:001/00 is a normally closed stop button. I:001/02 is a normally open limit switch. Describe the operation once the start button is momentarily depressed. When the stop button is pressed, do all outputs turn off? Why or Why not? Give an example where a program like this can be used. Ladder Diagram #2: Please review the following and answer the questions below. If the value located at N7:0 is 12, what is the resultant value at N7:3? If the value located at N7:3 is 80, what was the value at N7:0? If the value located at N7:2 is 30, what was the values at N7:0 and N7:1, and what is the value at N7:3? Ladder Diagram #3: Fig. 2 Refer to Fig. 2 to answer question 2a through 2e 2a) What is the starting sequence of the motor, M1, M2 and M3 ? 2b) From the time the START SWITCH is pressed, how long does it take before the last motor is ON ? 2c) How long is the delay between the starting of M1 and M2 ? 2d) How long is the delay between the starting of M1 and M3 ? 2e) How long is the delay between the starting of M2 and M3 ? Ladder Diagram #4 Please review the following program and answer the questions. If C5:1.ACC is equal to 3, what happens? How long is it before O:001/02 turns on and how long is it on? When is the done bit set on counter C5:1? Ladder Diagram #5: In the following ladder program, what would be the content of B3:20 when the content of the Accumulated Value Word of counter C5:0 is equal to the content of N7:10 for the above ladder program? Given: Accumulated Value of the Counter C5:0 = 100 and N7:10 = 100 Given: B 3:15 = 000011112 and B3:16 = 001100112  Ladder Diagram #6: Refer to Fig. 3 to answer question 3a. Fig. 3 3a) The OTE instruction (O:001/07) will be energized if the content of N7:1 is equal to what? Refer to Fig. 4 to answer q