libretto4202-01-1.doc-ICIntracom.docVIP

16/24/32-Port 10/100Mbps Fast Ethernet Switch USER’S MANUAL 520188 I-SWHUB-3200 FCC COMPLIANCE STATEMENT This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the instructions provided with the equipment, may cause interference to radio and TV reception. The equipment has been tested and found to comply with the limits for a Class B computing device in accordance with the specifications in Subpart B of Part 15 of FCC rules, which are designed to provide reasonable protection against such interference in a commercial environment. However, there is no guarantee that interference will not occur in a particular installation. If you suspect this equipment is causing interference, turn your switch on and off while your radio or TV is showing interference to determine the source of the interference. You can try to correct the interference by one or more of the following measures: Reorient the receiving radio or TV antenna where this may be done safely. To the extent possible, relocate the radio, TV or the other receiver away from the equipment. Plug the computer which has the equipment installed into a different power outlet so that equipment and the receiver are on different branch circuits. If necessary, you should consult the place of purchase or an experienced radio/ television technician for additional suggestion. CAUTION : The phone jack cannot be connected to telephone system. Introduction Congratulations on your purchase of this 16/24/32-port Fast Ethernet Switch. This high performance switch provides Fast Ethernet ports to segment network traffics, extend Fast Ethernet connection distance, and convert data packets between different transmission speeds. This Switch provides 16/24/32 shielded RJ-45 ports. These are 10BaseT/100BaseTX Auto-negotiation ports. This switch utilize stored-and-forward switching architecture that filters and forwards data after the complete data packet is rece