MultioutputFlybackConverterwithSwitching-IJRDET.PDFVIP

International Journal of Recent Development in Engineering and Technology Website: (ISSN 2347-6435(Online) Volume 2, Issue 6, June 2014) Multi output Fly back Converter with Switching/Linear Post Regulators Naresh K M 1, Umavathi M 2, Mohan HR3 1P G student, 2Assistant professor, Electrical and Electronics, BMS College of Engineering, Karnataka, India 3Deputy Manager, Central DE (power supp ly), Bharat Electronics Limited, Karnataka, India Abstract— In high power pulsed radar transmitter the As it is very difficult to take feedback signal for control gridded TWT is used as main power amplifier, the grid circuit from secondary side of multi output fly back control includes the grid positive and grid negative power converter to primary side, because voltage level of primary supplies, which control the beam ON and OFF of TWT. The side is 28V DC whereas voltage level of secondary side of negative voltage is used to maintain the TWT in an off state fly back converter is 10kV with respect to ground, as (bias), while positive voltage is used to turn on the TWT (drive). The grid supplies are referenced to cathode and thus shown in fig. 1.1 Hence there is a need of high efficiency float at high potentials making the design of these converters post regulators for next stage. Here for secondary side Two challenging, thermally as well as electrically. In this paper, an outputs are high grid drive and grid bias and housekeeping approach is presented that is easy to use, low cost effic