multiscalefrictionmodelingforsheetmetalforming-Tata.PDFVIP

MULTISCALE FRICTION MODELING FOR SHEET METAL FORMING Authors 1 2 3 4 J. HOL , M.V. CID ALFARO , M.B. DE ROOIJ AND T. MEINDERS 1 Materials innovation institute (M2i) 2 Corus Research Centre – 3 University of Twente, Faculty of Engineering Technology, group of Surface Technology and Tribology 4 University of Twente, Faculty of Engineering Technology, chair of Forming Technology Please Note Care has been taken to ensure that the information herein is accurate, but Tata Steel and its subsidiary companies do not accept responsibility for errors or for information which is found to be misleading. Suggestions for or descriptions of the end use or applications of products or methods of working are for information only and Tata Steel and its subsidiaries accept no liability in respect thereof. Before using products supplied or manufactured by Tata Steel the customer should satisfy themselves of their suitability All drawings, calculations and advisory services are provided subject to Tata Steel Standard Conditions available on request. MULTISCALE FRICTION MODELING FOR SHEET METAL FORMING 1 2 3 4 J. HOL , M.V. CID ALFARO , M.B. DE ROOIJ AND T. MEINDERS 1 Materials innovation institute (M2i) – P.O. box 5008 – 2600 GA Delf t – The Netherlands 2 Corus Research Centre – P.O. box 10000 – 1970 CA IJmuiden – The Netherlands 3 University of Twente, Faculty of Engineering Technology, group of Surf ace Technology and Tribology – P.O. box 217 – 7500 AE Enschede – The Netherlands 4 University of Twente, Faculty of Engineering Technology, chair of Forming Technology – P.O. box 217 – 7500 AE Ensc