BMW325cuptechnicalregulations1.GENERAL1.1Race.docVIP

BMW 325 cup technical regulations 1. GENERAL 1.1 Race carOnly series production cars manufactured by BMW AG with model code E36?325i with either saloon or coupe bodywork are eligible to participate. There are allowed to use only original or similar parts, unless these regulations state differently.  1.2 ChangesAll changes are forbidden, unless allowed by these regulations. It is forbidden to machine or change the original parts in any way. Reducing weight by drilling, removing material or replacing with lighter materials is forbidden. Making changes to construction or working principal of components is forbidden, unless allowed by these regulations.1.2.1 Parts that may be removed from the race car are listed in 3.1.12. 1.3 Original partOriginal parts are considered hereafter parts meant for BMW E36?325i car by the manufacturer with the part number and markings of the original part. 1.4 Similar partSimilar part must resemble original part in terms of function, material and dimensions, except for manufacturers part number. 1.5“Free” part Free means that the original part, as well as its function(s), may be removed or replaced with a new part, on condition that the new part has no additional function relative to the original part. 1.6 FuelFuel in use must be unleaded (up to 0,013g/L) and comply with FIA International sporting code Appendix J article 252 section 9.1. It is allowed to use only unleaded gasoline with octane rating RON95 and RON98 that is available through retail chains. Racing fuels are forbidden. Adding fuel additives is forbidden. 1.7 Minimum weightMinimum weight of the car (including the driver and his driving gear) under parc fermé rules, is 1280 kg. It is allowed to use weight ballast, according to Super 2000 rules, FIA International sporting code Appendix J article 263. 1.7.1 Minimum weight in long 45min race If two drivers take part in the long race in one car, the minimum weight is calculated with average weights of two drivers.(1280