《碳纤维----万明珍》.pdfVIP

关庆丰等：碳纤维增强摩擦材料的摩擦表面层研究 碳纤维增强摩擦材料的摩擦表面层研究 碳纤维增强摩擦材料的摩擦表面层研究 碳碳纤纤维维增增强强摩摩擦擦材材料料的的摩摩擦擦表表面面层层研研究究 关庆丰； 万明珍； 邹阳； 蔡杰； 陈康敏 (江苏大学材料科学与工程学院 镇江 212013) 摘要： 摘要： D-MS 摘摘要要：：利用 摩擦磨损实验机研究了碳纤维增强摩擦材料的摩擦磨损性能，并利用扫描电镜和能谱仪对其表面结构和微 区成分进行了观察和测定，对热重分析试验的结果和摩擦磨损性能试验的结果进行了分析。结果表明：碳纤维摩擦材料在 300℃内随温度升高摩擦磨损性能无明显降低，摩擦系数有所提高。碳纤维摩擦材料摩擦表面可分为富铁层、热力疏松层、 变形强化层与基体四层。摩擦表面工作层对材料表面获得稳定的摩擦磨损性能起重要作用。碳纤维的高导热性对材料的摩擦 表面层结构有重要影响，它有利于减少热影响表面层深度，在本试验条件下，摩擦热影响表面层的深度约为0.55mm。 关键词：碳纤维 摩擦材料 摩擦表面层 A STUDY OF TRIBOLOGICAL SURFACE LAYER OF CARBON FIBER REINFORCED FRICTION MATERIALS Guan Qingfeng; Wan Mingzhen; Zou Yang; Cai Jie; Chen Kangmin (Jiangsu Univerrsity , Zhenjiang , 212013, China) Abstract Abstract AAbbssttrraacctt: The friction and wear behaviors of carbon fiber reinforced friction materials (CFRFM) were investigated using a D-MS tester. The microstructures and constitutions of the CFRFM surface layer were measured using scanning electronic microscope (SEM) and energy dispersive spectroscopy (EDS) respectively; and their influence factors were analyzed according to the experiment results of thermo gravimetric analysis (TGA) and tribological properties. The experimental results show that the tribological properties of CFRFM do not reduce evidently, and friction coefficient has a small amount of increasing during temperature rising between 100- 300 ℃. The surface of CFRFM consists of four layer: work layers, i.e. iron-rich layer, which plays an important role in improving tribological properties of the material surface, thermodynamic loosened layer, reinforced layer and substrate; high heat conductivity, favorable to decrease the depth of the heat affected layer (HAL) on the friction surface, has an important effect