本科毕设基于串口通信的字符终端的设计与实现 外文翻译.docVIP

本科毕业设计 英文翻译 专业名称 电子信息工程 学生姓名 指导教师 完成时间 2013.06 本科毕业设计英文翻译 指导教师评阅意见 学生姓名： 班级：122902 得分： 请指导教师用红笔在译文中直接进行批改，并就以下几方面填写评阅意见，给出综合得分（满分按15分计）。 1、专业术语、词汇翻译的准确性； 2、翻译材料是否与原文的内容一致； 3、翻译材料字数是否符合要求； 4、语句是否通顺，是否符合中文表达习惯。 指导教师（签名）： 年 月 日 Serial Communication Based Character Display Terminal To introduce With microcontroller and microprocessor technology continues to evolve, especially in the field of network technology widely used in the monitoring and control by the PC and multi-single chip consisting of multi-machine network monitoring and control system has become the SCM technology development in one direction. Computer and computer or computer data transfer between the terminal can use a serial communications and parallel communications in two ways. Since the serial communication line with the use of small, low cost, especially in the long-distance transmission, the number of lines characteristic avoids inconsistencies which are widely used. In serial communications, require communicating parties have adopted a standard interface that allows different devices can be easily connected together for communication. RS-232-C interfaces (also known as EIA RS-232-C) is the most commonly used as a serial communication interface. It was in 1970 by the American Electronics Industry Association (EIA) joint Bell System, modem manufacturers and computer terminal manufacturers jointly developed a standard for serial communications. Its full name is data terminal equipment (DTE) and data communications equipment (DCE) serial binary data exchange interface between technical standards, This standard requires the use of a 25 foot DB25 connector, the connector of each primer pin signal content to be provided, but also on the level of a variety of signals to be provided. A combination of single-chip serial com