1 000 kV特高压固定串联补偿装置.pdfVIP

第 37 卷 第 8 期 电 网 技 术 Vol. 37 No. 8 2013 年 8 月 Power System Technology Aug. 2013 文章编号：1000-3673 （2013 ）08-2218-07 中图分类号：TM 721 文献标志码：A 学科代码：470·4051 1 000 kV 特高压固定串联补偿装置 关键元件工作条件研究 张媛媛，班连庚，项祖涛，林集明，郑彬，张艳萍，韩彬，韩亚楠 （中国电力科学研究院，北京市海淀区 100192 ） Research on Working Condition of Key Components for Fixed Series Compensation in 1 000 kV UHVAC Power Transmission Project ZHANG Yuanyuan, BAN Liangeng, XIANG Zutao, LIN Jiming, ZHENG Bin, ZHANG Yanping, HAN Bin, HAN Yanan (China Electric Power Research Institute, Haidian District, Beijing 100192, China) ABSTRACT: Based on the extension project of 1 000 kV AC 工程，利用电磁暂态程序(EMTP)，研究了区外和区内故障 power transmission demonstration project from Changzhi via 时，1 000 kV 特高压串补关键元件工作条件。研究首次提出： Nanyang to Jingmen and utilizing electromagnetic transients 采用金属氧化物限压器(metal oxide varistor ，MOV)-并联间 program (EMTP) the working conditions of key components 隙组合作为特高压串补的过电压保护措施；区外故障时仅由 for fixed series compensation in 1 000 kV UHVAC power MOV 限制电容器的过电压，间隙不动作；区内故障时，火 transmission under internal faults, namely the faults occurred 花间隙及旁路开关可以动作，从而将电容器和 MOV 旁路； between the circuit breakers at both sides of the line where the 特高压串补过电压保护水平为 2.3 pu ；长南I 线和南荆 I 线 series compensation locates, and the external fault, namely all 串补MOV 的最大能耗水平分别为 57 MJ/相和 45 MJ/相；采 faults except internal faults, are researched. It is first proposed 用“电抗器+MOV 串电阻”型阻尼回路作为串补电容器的 to use the combination of metal oxide varistor (MOV) with 放电阻尼装置，电容器放电回路的自振频率约为 300 Hz；短 parallel gap as the overvoltage protection mea