标准《高压开关设备和控制设备的抗震要求》存在的问题及建议.pdf

37 卷 5 期 电 网 技 术 Vol. 37 No. 5 2013 年5 月 Power System Technology May 2013 文章编号：1000-3673 （2013 ）05-1432-08 中图分类号：TM 752 文献标志码：A 学科代码：470 4051 标准《高压开关设备和控制设备的抗震要求》 存在的问题及建议 尤红兵 赵凤新 （中国地震灾害防御中心，北京市朝阳区 100029 ） Existing Defects in Recommended National Standard Seismic Qualification for High-Voltage Switchgear and Controlgear” and Corresponding Proposals YOU Hongbing, ZHAO Fengxin (China Earthquake Disaster Prevention Center, Chaoyang District, Beijing 100029, China) ABSTRACT: “Seismic qualification for high-voltage 0 引言 switchgear and controlgear” (GB/T 13540—2009) is a newly [1-7] 汶川地震后，许多学者 对电气设备的震害原 revised recommended Chinese national standard that promotes 因及经验教训进行了深入研究，认为应加强电力设 the popularization and application of serial IEC standards in China. Based on the actual situation in China, the defects 施抗震相关标准的编制工作，并适当提高我国电气 existing in this revised standard, such as seismic fortification 设备的抗震设防标准,为坚强智能电网的建设奠定 goal and level and required response spectrum (RRS) and so on, [8] 坚实基础 。 are pointed out. Through the analysis on probabilistic seismic GB/T 13540—2009 《高压开关设备和控制设备 hazard at typical region, some modification proposals on the [9] 的抗震要求》 为新修订的国家标准，它替代了 selection of seismic performance levels of electrical equipments are put forward. The applicability o