设计类说明书参考范例摘要.docVIP

江阴职业技术学院 毕业设计说明书 课 题： 轴承座加工工艺规程及钻2个 Φ6的孔和 铣底面夹具设计 子课题: 同课题学生姓名: 专 业 机械制造与自动化 学生姓名 佟阳 班 组 学 号 指导教师 吴松乾 完成日期 摘 要 内容摘要：工艺设计的夹紧加工过程基于设计。 ABSTRACT Process design for clamping some machining process and the left gear box shell parts based on this design. The plane engaging surface hole and the left main gear box shell parts. In general, the surface machining accuracy of the engaging hole machining accuracy. Therefore, the design of the surface after the first hole. In the rough and finish machining accuracy assurance engagement step hole divided clearly and the drilling plane. As the selection criteria and standards and the fine hole surface of the output shaft is supported by two big holes in the input shaft of the gear box and the left shell. The main process in the top surface plane and the left support engagement hole machining to arrange the supporting hole drilling technology in the engagement position. And the top plane and the other process technology in drilling hole position of engagement with the outside, but in the later process. Clamp for clamping the multi-target pneumatic fastening fastening method and fastening must not rely on the binding mechanism. Therefore, the production efficiency is high. The application in the mass production line. It can meet the design Requirements.Key words: Angle gear seat parts; fixture; 目 录 摘 要 II ABSTRACT III 第一章 加工工艺规程设计 1 1.1 零件的分析 1 1.1.1 零件的作用 1 1.2 轴承座加工的主要问题和工艺过程设计所应采取的相应措施 2 1.2.1 孔和平面的加工顺序 2 1.2.2 孔系加工方案选择 3 1.3 轴承座加工定位基准的选择 4 1.3.1 粗基准的选择 4 1.3.2 精基准的选择 4 1.4 轴承座加工主要工序安排 4 1.5 机械加工余量、工序尺寸及毛坯尺寸的确定 7 1.6确定切削用量及基本工时（机动时间） 9 1.7 时间定额计算及生产安排 33 第二章 钻Φ6孔夹具设计 39 2.1定位基准的选择 39 2.2 钻削力计算 39 2.3定位元件的设计 40 2.4 定位误差分析 41 2.5 夹具体槽形与对刀装置设计 42 2.6 夹紧装置及夹具体设计 44 2.7 夹具设计及操作的简要说明 45 第3章 镗Φ14孔夹具的设计 46 3.1 问题的指出 46 3.2 定位机构 46 3.2.1“一面两销”定位