- 7
- 0
- 约5.71万字
- 约 8页
- 2016-03-14 发布于安徽
- 举报
异步电机在线参数观测及其损耗控制策略.pdf
第 33 卷 第 6 期 中 国 电 机 工 程 学 报 Vol.33 No.6 Feb.25, 2013
112 2013 年 2 月 25 日 Proceedings of the CSEE ©2013 Chin.Soc.for Elec.Eng.
文章编号:0258-8013 (2013) 06-0112-08 中图分类号:TM 301 文献标志码:A 学科分类号:470·40
异步电机在线参数观测及损耗控制策略
徐飞,史黎明,李耀华
( 中国科学院电力电子和电气驱动重点实验室( 中国科学院电工研究所) ,北京市 海淀区 100190)
Strategy Research on Induction Motor On-line Parameter Observer and Loss Control
XU Fei, SHI Liming, LI Yaohua
(Key Laboratory of Power Electronics and Electric Drive, Institute of Electrical Engineering, Chinese Academy of Sciences,
Haidian District, Beijing 100190, China)
ABSTRACT: On-line parameter observation is studied in [1]
辆安全牵引 。研究电机参数变化对异步电机损耗
order to improve the efficiency of loss optimized control 控制的影响和基于在线参数观测的损耗最优控制,
(LOC). The influence of the optimized excitation current, flux 能够提高轨检车的运行效率。该研究成果对其它交
angle and then the loss of induction motors by parameter
通系统的异步电机牵引效率控制也有参考价值。
variation are analyzed thoroughly. An adaptive parameter
observer of Lm, which is independent on resistances, is 目前,常用的异步电机损耗最优控制方法有离
presented in this paper. The simple and effective solution of the 线法和在线法,参见图 1。离线法分为电磁仿真优
rotor current is proposed to improve the conventional method. 化设计法和优化运行点法。其中,电磁仿真优化设
A LOC with parameter observation is implemented in our 计采用有限元仿真分析设计异步电机,通过优化电
multi-motor platform. The experimental results show the novel
机的参数设计实现电机损耗的降低。优化运行点法
solution can calculate the rotor current effectively. The Lm
obtained by proposed method meets the practical variety 预设电机工作点使其高效率运行。离线法适用于电
feat
您可能关注的文档
- 一种用于提高风电变流器中功率器件寿命的混合空间矢量调制方法.pdf
- 一种用于配电系统谐振抑制及其谐波治理的新型PAPF控制方法.pdf
- 一种电力系统谐波信号的加窗频移算法.pdf
- 一种电流自适应的尖峰电压限制型功率管关断控制方法.pdf
- 一种电能质量扰动监测和识别新方法.pdf
- 一种表贴式永磁同步电机电流矢量闭环I_f控制方法.pdf
- 一种计及其运行状态的风电机组短期停运模型.pdf
- 一种软件锁相环和电压跌落检测新算法.pdf
- 一种达到最高效率的新型软切换三电平逆变器拓扑结构.pdf
- 一种适用于固态直流断路器的IGBT串联均压电路.pdf
- 计量规程规范 JJF 2362-2026测量设备校准间隔的确定导则.pdf
- 《JJF 2362-2026测量设备校准间隔的确定导则》.pdf
- JJF 2362-2026测量设备校准间隔的确定导则.pdf
- JJF 2373-2026测量不确定度在法制计量符合性评定中的应用.pdf
- GB/T 27997-2026造船门式起重机.pdf
- 计量规程规范 JJF 2373-2026测量不确定度在法制计量符合性评定中的应用.pdf
- 《JJF 2373-2026测量不确定度在法制计量符合性评定中的应用》.pdf
- 中国国家标准 GB/T 27997-2026造船门式起重机.pdf
- 《GB/T 27997-2026造船门式起重机》.pdf
- GB/T 31487.2-2025直流融冰装置 第2部分:换流器.pdf
原创力文档

文档评论(0)