圆锥形中空钢管-钢筋混凝土叠合短柱轴压力学性能研究.pdfVIP

29 卷增刊II Vol.29 Suppl II 工 程 力 学 2012 年 12 月 Dec. 2012 ENGINEERING MECHANICS 195 文章编号：1000-4750(2012)Suppl II-0195-06 圆锥形中空钢管钢筋混凝土叠合短柱 轴压力学性能研究 任庆新，孙明海，贾连光，刘德清 (沈阳建筑大学土木工程学院，辽宁，沈阳 110168) 摘 要：该文利用有限元软件ABAQUS 建立了圆锥形中空钢管-钢筋混凝土叠合短柱轴压力学性能分析的有限元 计算模型，并进行了12 个圆锥形中空钢管-钢筋混凝土叠合短柱轴压试验。有限元计算与试验所得的荷载-位移全 过程曲线及破坏形态吻合较好。在此基础上对内钢管与混凝土之间的相互作用进行了分析，并对锥度、材料强度、 空心率、配筋率等参数对轴压时叠合短柱初始刚度、极限承载力及荷载-位移曲线的影响进行了比较。 关键词：圆锥形；中空钢管-钢筋混凝土；叠合短柱；轴压；有限元分析 + 中图分类号：TU317.1; TU398 .9 文献标志码：A doi: 10.6052/j.issn.1000-4750.2012.05.S057 STUDY ON CONICAL HOLLOW STEEL TUBE-REINFORCED CONCRETE LAMINATE STUB COLUMNS SUBJECTED TO AXIAL COMPRESSION REN Qing-xin , SUN Ming-hai , JIA Lian-guang , LIU De-qing (School of Civil Engineering, Shenyang Jianzhu University, Shenyang, Liaoning 110168, China) Abstract: A finite element analysis (FEA) model for conical hollow steel tube-reinforced concrete laminate stub columns subjected to axial compression was developed in the flatform of ABAQUS. The tests of 12 stub columns under axial compression were conducted. The predicted load versus deformation curves and failure modes were in good agreement with the testing results. The FEA model was then used to investigate the mechanisms of such composite columns further. The interactions between the inner steel tube and the reinforced concrete were analyzed. And then, the main parameters influencing the initial stiffness, ultimate strength and load-deformation curves such as taper, strength of the materials, hollow ratio and reinforcement ratio were investigated. Key words: conical; hollow steel tub