YG8材料ELID磨削过程中法向磨削力的研究.pdfVIP

2015年9月 机 床 与 液 压 Sep . 2015 第 43 卷第 17 期 M ACH INETOO L 3 HYDRAULICS Yol . 43 No . 1 7 D O I : 10.3969// i n . 1001-3881. 2015. 17. 028 YG8材料 ELID 磨削过程中法向磨削力的研究 许孔联 (湖南广播电视大学，湖南长沙410004) 摘要：在线电解修整（EleCt] lytisIn-P ]CesSDreSSin/，ELID ) 磨削方法由于其高效的镜面磨削效率而被广泛应用于硬、 脆性材料的镜面磨削加工。在精密平面磨床上加装喷嘴电解ELID 磨削系统，进行了硬质合金材料Y G 8 的ELID 磨削试验研 究。实验分析了磨削力与输出电压、脉冲频率、脉冲电流占空比、砂轮转速、工作台进给速度及磨削深度等ELID 磨削工 艺参数变化的影响关系。同时，在相同的磨削参数下，对 ELID 磨削和普通磨削条件下的磨削力进行对比分析。试验结果 表明：ELID 磨削能明显降低磨削力，与普通磨削相比较，能更好地实现Y G 8 的超精密磨削加工。 关键词：ELID磨削；法向磨削力；砂轮转速；进给速度；磨削深度 中图分类号：TG 58 文献标志码：A 文章编号：100卜388卜 （2015) 17-114-4 Research on Normal Grinding Force in ELID Grinding for YG8 XUKonglian (Hunan Radio T Y University，Changslia Hunan 410004， China ) Abstract ： As a high efficiency ultra-precision machining technology，Electrolytic In-Process Dressing ( ELID ) mirror grinding is widely applied in high accuracy machining of hard and brittle materials Y G 8. Three kinds of cemented carbides piece materials and the experiments were conducted by using nozzle-type ELID grinding system installed The variation of the grinding force with grinding process parameters : The output voltage， pulse frequency， pulse duty ratio, grinding wheel speed， the feed speed of table， grinding depth was analyzed. Meanwhile ， under the same grinding parameters， the grinding force of nozle-type ELID grinding and ordinary grinding were compared. The results show that nozle-type cantly reduce the grinding force， and nozle-type ELID grinding can realize the high quality Keywords : Electrolytic in-process dressing mirror grinding； Normal grinding force； Grinding wheel speed