WorkoverRigPlumger修井机分析.pptVIP

* 200 Plunger Pump and Manifolds 200型柱塞泵及吸入排出管汇部分 Ⅰ General Description of 200 Plunger Pump 200型柱塞泵概述 。 Model 3ZB2—170 Plunger Pump is a horizontal, single acting triplex plunger pump which consists of power end and fluid end. Power end consists of crank box,crank,connecting rod,cross head,cross head cover, etc. Fluid end consists of pump body,plungers, suction and discharge valve assemblies. Crank box is connected to cross head cover by 12 alloy studs and power end is connected to the fluid end by 12 alloy tie rods too. 3ZB20-170柱塞泵是我厂自行设计制造的一种卧式单作用三缸柱塞泵，它主要由动力端总成与液力端总成组成，动力端包括：曲轴箱、曲轴组件、连杆、十字头、十字头外壳体等；液力端包括：泵头体、柱塞及吸入排出凡尔总成等。曲轴箱与十字头外壳体由12个合金钢双头螺栓连接，动力端与液力端由12个合金钢接杆连接（双头螺栓与接杆螺纹连接），卸下液力端时，接杆留在动力端上。 For the plunger is connected to the pull rod by collar clamp, it is very convenient to disassemble and repair the fluid end. 3ZB20-170 Pump has the characters of small body, light weight,small displacement,low pressure and it is easy to operate and repair. The pump is a complicated equipment,improper operations will produce serious results.Please read the instructions carefully and know the mechanics and usage well before any operations. 柱塞与拉杆之间采用卡箍连接，拆卸和维修液力端很方便。3ZB20-170柱塞泵具有体积小、重量轻、排量及压力较小、操作维修方便等特点，适用于油田作业中压力及排量要求不大的场合。因为柱塞泵为设备作业之核心部件，操作不当会造成严重后果。因此，要求操作人员在使用设备之前，认真仔细地阅读说明书，熟悉其结构及使用要求。 Ⅱ Main Parameters主要技术性能参数 1、Max.input HP最大输入功率: 170KW（228HHP） 2、Continuous HP持续水功 112KW（150HHP） 3、Stroke冲 程： 101.6mm （4”） 4、Max. SPM最高冲次： 300 5、Plunger Diameter柱塞直径： 27 mm(5”) 6、Max.pressure最高压力： 20MPa 7、Max. displacement最大排量： 1.158L/Min 8、Weight重 量: 1250KG 9、Max.Rod load连杆最大负荷： 253KN 三、结构简介 200型柱塞泵 Ⅲ Structure Introduction 结构简介 1、Power End 动力端总成 Consists of crank box,crank,connecting rod,cross head,cross head holder,etc. 1 Crank box: Steel welding structure 2 Crank:alloy steel forging with integrated lubricating oil line. 3 Connecting rod and insert:connecting rod is made of steel c