MachineGuarding机械安全资料.ppt

* This presentation is designed to assist trainers conducting OSHA 10-hour General Industry outreach training for workers. Since workers are the target audience, this presentation emphasizes hazard identification, avoidance, and control – not standards. No attempt has been made to treat the topic exhaustively. It is essential that trainers tailor their presentations to the needs and understanding of their audience. This presentation is not a substitute for any of the provisions of the Occupational Safety and Health Act of 1970 or for any standards issued by the U.S. Department of Labor. Mention of trade names, commercial products, or organizations does not imply endorsement by the U.S. Department of Labor. * 29 CFR 1910, Subpart O * * All parts of the machine which move while the machine is working can cause mechanical hazards. These can include reciprocating, rotating, and transverse moving parts, as well as feed mechanisms and auxiliary parts of the machine. * 1910.212(a)(3)(i) (ii) * * In-running nip point hazards are caused by the rotating parts on machinery. There are three main types of in-running nips. Parts can rotate in opposite directions while their axes are parallel to each other. These parts may be in contact (producing a nip point) or in close proximity to each other (where the stock fed between the rolls produces the nip points). This danger is common on machinery with intermeshing gears and rotating cylinders. Another type of nip point is created between rotating and tangentially moving parts; for example, a chain and a sprocket, a rack and pinion, or the point of contact between a power transmission belt and its pulley. Nip points can also occur between rotating and fixed parts which create a shearing, crushing, or abrading action; for example, spoked handwheels or flywheels, screw conveyors, or the periphery of an abrasive wheel and an incorrectly adjusted work rest. * Prevent Contact - A good safeguarding system eliminates the possib