44DP800高强钢板点焊性能研究.pdfVIP

上半月出版 DP800高强钢板的点焊性能研究 于燕1,2。陈军1,2，贾坤宁3 (1．长春工业大学材料科学与工程学院，吉林长春130012；2．长春工业大学先进结构材料省部共建教育部重点实验室， 吉林长春130012；3长春工程学院，吉林长春130010) 摘 要：进行了DP800MPa级双相钢的点焊性能研究。对国产和瑞典双相钢的点焊接头进行金相分析、显微硬度测 试、剪切试验以及扫描断口分析，结果表明，双相钢点焊接头的断裂方式以韧性断裂为主；在同等焊接工艺下，国产钢板 点焊接头的剪切强度高于瑞典钢板点焊接头。国产钢板点焊接头的显微硬度略低于瑞典钢板。 关键词：双相钢；电阻点焊；焊接工艺；断裂断口 中图分类号：TGl42．41：TG453t9文献标识码：A on PerformanceofDP800 ResearchResistance Welding High Spot SteelSheet· Strength YU YanL2．CHEN JunL2。J队Kunnin93 MaterialsScienceand of Engineering,ChangehunUnivers】眵ofTechnology,Changehun (1．College AdvancedStructural Laboratoryof Materials，MinistryofEducation，ChangchunUnivers缈of 130012，Chimg3．Ch,mgehunCollege矿Engineering,Changchun130010，China) Abstract：Theofresistance forDP800MPa-levelsteelwereresearched． properties spotweldingapplication dual-phase The of steel indomesticandswedishWasstudied spotweldingperformancedual·phaseproduced bymetallographic and fracture resultsshowthatthe steel tests joint analysis，microhardncss，shearscanning analysis．The dual-phasewelding are same shear ofdomestic fracturemodes ductilefractures．Underthe spotwelding mainly weldingprocess，thestrength domesticis lowerthantheswedish is than themicrohardnessofthe jointhigherswedish，but slightly plates． Keywords：dual-phasesteel；