汽车空调压力测试.ppt

The vehicle must be at least 50°F or higher. Start the engine, open the windows, turn the blower on high and the AC to full cold. Start the recovery unit and open the high-side service valve only. Monitor the gauges. When the low gauge reaches 15psi make sure the compressor has shut down. If not turn off AC and allow the recovery unit to run. After the recovery unit shuts off monitor the gauges. If the pressure rises above 0psi start the recovery unit again. Continue this process unit the pressures stay below 0psi. Replace any parts required and install the low-side fitting. Install the high-side fitting. Check and verify that the vehicle has a HPCS. If not install one per bulletin. Determine the original R-12 charge amount. Calculate the R-134a using the above formula. Connect the R-134a cart to the vehicle. Program the evacuation for 30 minutes. Determine the type and amount of oil to add to the system. After the evacuation is complete add the new oil to the system. Charge with the new calculated amount of R-134a. After charging is complete run an AC performance test on the system to determine if the system is performing Leak test the system.系统泄漏测试 Fill out and install the retrofit label in a prominent location on the vehicle. 填写并在车辆的显著位置黏贴改造标签。 Blacken out the R-12 system capacity on the refrigeration label. Do not remove or cover the label. * Welcome to Heating Ventilation and Air Conditioning Copyright 2003 General Motors Corporation RETROFITTING空调压力测试MODULE 7PPT a7 m07 Final The material contained in this course component was accurate and current at the time of course development. ALL PHOTOGRAPHS ARE COURTESY OF PRENTICE HALL’S CHEK CHART SERIES HEATING VENTIALTION AND AIR CONDITIONING Objective目标 Have knowledge of the retrofit procedure and be able to demonstrate this knowledge by performing a retrofit 掌握空调压力测试过程 Retrofitting Refer to bulletin # 43-12-07e For the correct procedure Applicable to the vehicle Retrofitting Retrofitting Retrofitting Retr