利用红外热像仪判断21CrMo10钢铸锭缺陷研究.pdfVIP

第 35 卷 第 10 期 红 外 技 术 Vol.35 No.10 2013 年 10 月 Infrared Technology Oct. 2013 利用红外热像仪判断 21CrMo10 钢铸锭缺陷的研究 1 1 1 2 2 1 唐雯聃 ，宋书雅 ，赵俊学 ，陈远清 ，仇圣桃 ，李小明 （1.西安建筑科技大学 冶金工程学院，陕西 西安 710055 ；2.钢铁研究总院连铸技术国家工程研究中心，北京 100081） 摘要：利用红外热像仪直接观察与测定了钢锭凝固过程中铸模外表面的温度分布，对几个关键部位 的温度随时间变化的趋势及规律进行了对比和分析，对可能存在的铸锭缺陷进行了判断。采用金相 法和氧含量分析法对铸锭的显微结构进行分析，并结合统计数据对结果进行确认。证明利用红外热 像仪判断铸锭缺陷在一定程度上是可行的。 关键词：红外热像仪；铸锭缺陷；铸模；金相法；氧含量分析法 中图分类号：TF771.1 文献标识码：A 文章编号：1001-8891(2013)10-0665-04 Study on Judging Ingot Defects of 21CrMo10 Steel by Infrared Thermal Imager 1 1 1 2 2 1 TANG Wen-dan ，SONG Shu-ya ，ZHAO Jun-xue ，CHEN Yuan-qing ，QIU Sheng-tao ，LI Xiao-ming (1.School of Metallurgical Engineering, Xi’an University of Architecture and Technology, Xi’an 710055, China; 2.National Engineering Research Centre of Continuous Casting Technology, Central Iron and Steel Research Institute, Beijing 100081, China) Abstract ：In this article the temperature distribution of mold’s surface in solidification process of the ingot was observed and measured by infrared thermal imager directly. We compared and analyzed the trend and regularity of the temperature change with time in several key points. And the possible ingot defects were speculated in correspondence. The microstructure of ingot was analyzed by the metallographic method and oxygen content analysis. The result was confirmed according to the statistical data. It is proved that judging ingot defects by infrared thermal imager is feasible to some extent. Key words ：infrared thermal imager ，ingot defects