用粉煤灰和铁尾矿制备高强混凝土.pdfVIP

26 3 Vol.26 No.3 2 0 1 2 6 CHINESE JOURNAL OF MATERIALS RESEARCH June 2 0 1 2
∗       ( 100083)  , X (XRD) (SEM) , , 100.1 MPa, 20.6 MPa, 86.4% C–S–H , Ca(OH)2 , , , TB321 1005-3093(2012)03-0295-07 Preparation of High–strength Concrete by Using Fly Ash and Iron Ore Tailings as Major Raw Materials LIU Jia NI Wen∗∗ YU Miao (State Key Laboratory of High–Efficient Mining and Safety of Metal Mines, Ministry of Education of China, University of Science and Technology Beijing, Beijing 100083) * Supported by National High Technology Research and Development Program of China No.2012AA062405. Manuscript received March 12, 2012; in revised form May 10, 2012. ** To whom correspondence should be addressed, Tel:(010 E–mail:niwen@ces.ustb.edu.cn ABSTRACT A high–strength concrete material was prepared by using fly ash and iron ore tailings as major raw materials. Reaction products and microstructure of hydrated harden samples of the high– strength concrete material were analyzed by XRD and SEM methods, and the influences of several factors, such as proportion of iron ore tailing, water–binder ratio and dosage of super plasticizer, on the mechanical properties of the high–strength concrete material were investigated. The results show that the prepared concrete material is composed of large ratio of solid waste up to 86.4% (mass fraction), and its compressive strength reached to 100.1 MPa with a flexural strength of 20.6 MPa