IEC60884家用插头插座介绍分析报告.ppt

* Plaatjes toevoegen * Slide changed, plaatjes verschillende producten * Slide changed * Changed slide * § 30.2 Static damp heat test Three specimens is submitted to two damp heat cycles in accordance with IEC 60068-2-30. Regaining ambient temperature. Then the specimens are submitted to the following tests: – insulation resistance and electric strength test, in accordance with clause 17, – abrasion test, in accordance with 24.7 * § 30.3 Test at low temperature Three specimens is maintained at (–15 ± 2) °C for 24 h. Regaining ambient temperature. Then the specimens are submitted to the following tests: – insulation resistance and electric strength test, in accordance with clause 17, – abrasion test, in accordance with 24.7 * § 30.4 Impact test at low temperature -15±2℃;24H; 100±1g fall from 100mm Four impacts , rotating it through 90°between impacts. No cracks of the insulating sleeves * Slide changed * Slide changed * Changed Slide ANNEX B INSCANNEN EN INPLAKKEN * Slide changed * Slide changed * Slide changed * Slide changed, evt plaatje contactdoos schuko. Plaatje IP earthing * Slide changed * Slide changed * Slide changed, Foto one-way * Slide changed, filmpje breken aardcontact, plaatje cord anchorage? Plaatje torque force * Slide changed * Slide changed, fixed module (vb Hongyi) * Slide changed * Previouse slide deleted, this on changed * Slide changed, Plaatje meten van kracht * Slide changed. * Slide Changed, Maak nieuw filmpje! * Slide changed * Slide changed * Additional slide. Foto stekker contactbus test met kaliber * Slide changed * Slide changed * Slide changed * Slide changed * Filmpje valtrommel * Slide changed, nieuw filmpje * FOTO diameter afdruk meetwijze * slide changed * § 17.2 electric strength A voltage of sine-wave form(正弦波形) , having a frequency of 50 Hz or 60 Hz, is applied for 1 min between the parts indicated in 17.1. The test voltage shall be as follows: – 1 250 V for accessories having a rated voltage up t