垫圈冲压模具设计 毕业论文.docVIP

垫圈冲压模具设计 摘 要 冲压是机械制造业中一种较先进的加工方法，与切削加工相比，具有材料利用率高、制品力学性能好，互换性强、生产效率高等优点。制件精度高由于是在冲床的一次行程内，完成数道冲压工序。因而不存在累积定位误差。使冲出的制件内外形相对位置及各件的尺寸一致性非常好，制件平直。生产效率高模具结构紧凑，面积较小由于采用弹压卸料装置，使冲制出的工件平整，表面质量好。采用打料杆将工件或废料从凹模孔中打下，因而工件或废料不在凹模孔内积聚，可减少工件可废料对孔的涨力。从而可减少凹模的壁厚，使凹模的外形尺寸缩小，节约模具材料 根据零件图的结构分析,该零件采用倒装复合模具冲压比较合理。该复合模具结构特点是凸模安装在下模座上，采用弹压卸料装置将废料从凸模上卸下。而它的凹模是安装在模座上，因而就存在着如何将凹孔内的工件从孔中排出的问题。 关 键 词：THE DESIGN OF LCD DISPLAY SYSTEM BASED ON MCU ABSTRACT The presses to be a more advanced preparation method of the mechanical manufacturing industry, compared with cutting and processing, have materials utilization ratios high, the products are good of performance in mechanics; the interchangeability is strong, advantage that production efficiency is higher. This set of that I designed are repaired, wash the whole compound mould, adopt and invert the compound mould to press, because have a lot of advantages to invert the mould, for example: Make pieces of precision high, because of in one journey of puncher, finish several press the process. Therefore does not accumulate localization errors. Make the go out pieces of internal and external shape relative position and size of every consistency very kind, and make it straight. It is high in efficiency to produce, the mould structure is compact, and the area is relatively small. Because of adopt, suppress tripper, make, wash work piece produced to make level, the surface is of high quality. Adopt and send the material pole and lay the work piece or waste material from the concave model hole, therefore work piece or waste material is not gathered in the concave model hole , can reduce the work piece waste material strength of rising to the hole. Thus the wall that can reduce the concave mould is thick, make the external dimension of the concave mould dwindle, save the mould material This part adopts and inverts the compound mould to press more reasonable according to the structure of the part picture. The structural characteristic of this co