毕业论文（参考）分子筛变压吸附研究报告.docxVIP

院级本科生科技创新项目 研究报告 项目名称 变压制富氧分子筛延长寿命的研究 立项时间 2014年10月 计划完成时间 2015年12月 项目负责人 储万熠 学院与班级 冶金与生态工程学院 冶金1302班 北京科技大学教务PAGE \* MERGEFORMAT13 摘要 变压吸附制氧关键的因素是制氧吸附剂和制氧工艺。制氧吸附剂的性能优劣和使用寿命直接影响产品气的氧浓度和收率，氮吸附容量是评价制氧吸附剂性能优劣的一项重要指标。本课题首先对分子筛进行XRF分析、XRD表征和TEM表征探究分子筛的物理及化学性质，确定对分子筛造成影响的条件。 ANSYS FLUENT中的多孔介质模型可以模拟多孔介质内的流体流动、“三传一反”。PSA空分吸附床由固体吸附剂颗粒填充而成，气-固两相区可作为多孔介质，因此可基于多孔介质模型对变压吸附空分吸附床进行模拟，从而得到床层内气体的流动状态和组分浓度分布情况。为研究提高分子筛寿命的研究提供可靠有效的实验数据。  Research of Prolong the Life of Pressure-Swinging-Oxygen-Making Molecular Sieve Abstract The key factor of the pressure swinging oxygen making is oxygen adsorbent and oxygen process. The quality and service life of oxygen adsorbent direct impact on the oxygen concentration and yield of product gas, nitrogen adsorption capacity of the oxygen sorbent performance evaluation of the merits of an important indicator. This paper first do XRF analysis, XRD and TEM characterization of physical and chemical properties of molecular sieve inquiry to determine the impact on molecular sieves conditions. The porous medium model in ANSYS FLUENT can simulate fluid flow in porous media. PSA air separation adsorbent bed is filled by a solid sorbent particles, gas - solid two phase region as a porous medium, thus can simulate the pressure swing adsorption air separation adsorbent bed based on the porous medium model, resulting in the flow state within the bed of gas and component concentration distribution for providing valid and reliable experimental data of improving molecular sieve’s life.  目录  TOC \o 1-3 \h \z \u  HYPERLINK \l _Toc438678959 1 引言  PAGEREF _Toc438678959 \h 1  HYPERLINK \l _Toc438678960 1.1 课题研究背景  PAGEREF _Toc438678960 \h 1  HYPERLINK \l _Toc438678961 1.2 课题研究目的及意义  PAGEREF _Toc438678961 \h 1  HYPERLINK \l _Toc438678962 2 原矿矿物学分析  PAGEREF _Toc438678962 \h 2  HYPERLINK \l _Toc438678963 2.1分子筛XRF分析  PAGEREF _Toc4386789