设计一座年产生铁 300 万吨的高炉车间 毕业设计(论文)说明书.doc

毕业设计说明书 设计（论文）题目：设计一座年产生铁 300 万吨的高炉车间摘 要 按照设计说明书的要求，设计一座年产300万吨的炼钢生铁的炼铁厂。该厂的高炉车间由2座有效容积2163立方米的高炉，车间布置形式采用半岛式布置。 高炉炼铁生产工艺流程主要包括六个系统：高炉本体系统、高炉车间原料系统、高炉送风系统、高炉喷煤系统、煤气除尘系统渣鉄处理系统。 其中高炉的炉衬设计方法采用的是均衡炉衬的方法，根据不同的冶炼条件砌筑不同的砖。冷却方式：炉身部分采用板壁结合的方式炉腰部分采用凸台冷却壁；炉缸和炉底采用光面冷却壁和水冷炉底结构。 设计的热风炉采用传统改进型内燃式热风炉。蓄热式和燃烧室在同一炉壳内这部分同时包括热风炉各种设备和阀门的选取计算。 上料系统采用的皮带机连续上料，同时增加了皮带的速度和宽度，满足高炉冶炼的要求。炉顶装料设备采用串罐式无料钟炉顶装料。喷吹系统增加了煤的数量，采用了单管路串罐式直接喷吹。煤气处理设备采用的是湿法除尘设备。 所涉及的计算有高炉和热风炉尺寸的计算、高炉的物料平衡和热平衡计算以及热风炉风机的选择等。关键词: 高炉；热风炉；湿法除尘；ABSTRACT The design’s task is to build an iron-making plant, which has two blast furnaces and each capacity is 2163m3. The plant generates 3000,000 tons iron every year. There are seven chapters in the design. The seven systems of the iron-making plant is follow: blast furnace system、raw material system、blast air blowing system、fuel injecting system、gas dust removal system、slag processing systems The BF lining adopted equalization lining method and was made of alumina brick and chayote in upper of BF and all carbon brick in the bottom of BF.The cooling methods were batten wall style in shaft, boss-cooling stave in bosh, smooth cooling stave in hearth and water-cooling stave in bottom of hearth. The air-stove was modified tradition style of internal combustion. The checker chamber and combustion chamber were in the same furnace shell and divided by heat insulation wall. And the combustion chamber was eye-style. Furthermore this part of the paper included the selection of various equipments and valves. The charging equipment used the belt machine to continuing supplying charge and the belt velocity and width were increased in order to meet the BF melting needs. The furnace roof equipment used string pot style of non-bell furnace roof. Injection system increased amount of coal and use single valve line sting pot direct injection. The gas treating system used hydro filter equipment. The computes in the paper have size of BF and air-stave, charge balance, heat balance and fan of air-stave