（参考）基于ARM的信号有效值检测模块—硬件设计.docVIP

本科毕业设计(论文) 题目：基于ARM的信号有效值检测模块—硬件设计 院 （系）： 电子信息工程 专 业： 电子信息工程 班 级： 学 生： 学 号： 指导教师： 2010年 6月基于ARM的信号有效值检测模块—硬件设计 摘 要 在信号检测及分析中，有效值是经常需要检测及测量的参数，对信号分析及相关信息的提取具有重要作用。课题综合利用ARM技术、有效值检测技术及串口通信技术，以ARM处理器LPC2103和有效值检测芯片AD637为核心完成了一套信号有效值检测模块的硬件设计。被测信号有效值的测量通过AD637进行，将信号的有效值转换成代表该有效值大小的直流电平；利用LPC2103内部的A/D转换器采集这一直流电平，将其转换为数字量交给LPC2103处理；ARM处理器LPC2103完成整个模块的控制工作，将A/D采集的有效值电平通过运算得到具体的有效值，然后通过数码管驱动在数码管上显示，同时通过串行口将检测到的数值发送到上位机程序界面进行同步显示。论文首先介绍了课题的设计方案，然后对课题实现相关技术及器件进行了介绍，在此基础上详细分析了模块的硬件原理设计。所设计的有效值检测硬件电路经测试，工作正常，功能满足设计指标要求。 关键词：信号有效值；ARM；LPC2103；AD637 The Hardware Design of Signal RMS Detection Module Based on ARM Abstract In the filed of signal detection and analysis, RMS parameter is often needed to be testedand measured and play an important role in signal analysis and related information extraction. This paper adopts LPC2103, the core processor with ARM architecture and AD637, the signal processing chip as well as using ARM, signal acquisition and processing, serial communication technology and so on to design and finished a RMS inspection module.In the design, the detected signal’s effective value is measured by the RMS AD637 chips, that is the detected signal‘s effective value will be converted to the equal DC level. Based on the LPC2103’s internal A/D converter, this acquired DC level will be converted to the digital quantity transferred to ARM processor for more process. ARM processor control the whole module,it archieves the specific RMS by computing the RMS level acquired by A/D converter, and then displays the digital value by driving display of the digital tube, as well as send the effective value to the PC program through serial port to perform a synchronizing display. This paper introduces the background, significance, the related technologies, hardware diagram design and the process of debug. Finally, the designed hardware circuit is tested and works well, satisfying the design requirem