注塑模毕业设计精要.docVIP

本科毕业设计（论文） 题目： USB电池充电器下端盖 的注射模设计 院系： 机电工程学院 专业： 机械工程及自动化 班级： 学号： 姓名： 指导教师： 完成日期：2013年4月26日 USB电池充电器下端盖的注射模设计 摘要 本文主要介绍的是USB电池充电器下端盖的注塑模具设计方法。首先分析了USB电池充电器下端盖制件的工艺特点，包括材料性能、成型特性与条件、结构工艺性等，并选择了成型设备。接着介绍了USB电池充电器下端盖注塑模的分型面的选择、型腔数目的确定及布置，重点介绍了浇注系统、成型零件、侧向分型抽芯机构、联合推出机构以及冷却系统的设计。然后选择标准模架和模具材料，并对注射机的工艺参数进行相关校核，充分考虑到模具零件的加工可行性。最后对模具的工作原理进行阐述，以及在安装调试过程中可能出现的问题进行总结、分析，并给出了相应的解决方法。 本文论述的USB电池充电器的注塑模具，采用三板式结构，即浇注系统凝料和制件在不同的分型面脱出，采用一模四腔的型腔布置，最后利用推杆和推管共同将制件推出。 关键词：注射模设计；充电器下端盖；点浇口；侧向分型抽芯机构；联合推出机构 The mould injection design of charger shell Abstract The designing methods of injection mould of the charger shell are mainly introduced in this paper. First, the technological characteristics are analyzed, including material properties, forming characteristics and conditions, the process of the structure, the forming equipment is selected. Then the parting line is selected, the number of cavities is determined. The specific introduction are made on gating system, cooling system, molding parts, steering mechanism, molding mechanism, and spacer parting institutions. Then the standard mould bases and Mould materials are selected, and the technological parameters of the forming equipment is checked. Finally, problems that may emerge during the mold installation process are analyzed and the appropriate solutions are provided. Point gate is used on the design of charger shell, that is pouring material and the plastic parts are ejected from different parting lines. there are four cavities in this mould, finally a stripper plate is used to push off the charger shells. Keyword: Injection mold design; Charger on the cover; Point gate; Side parting core-pulling mechanism ; Jointly launched institutions; 目录 摘要 Abstract 第一章 绪论...............................................1 1.1 选题的依据及意义..............................................1 1.2 国内外研究现状及发展趋势......................................1 第二章 任务设计要求...........................