LED开关电源毕业论文技术方案.doc

本科毕业设计(论文) 负温度系数开关电源的设计 学 院 物理与光电工程学院 专 业 电子科学与技术 （应用电子方向） 年级班别 2010级 学 号 学生姓名 指导老师 2014 年 6 月 论文封面书脊 摘 要 本文介绍一种以UC3842作为控制核心，根据UC3842的应用特点，设计了一种基于该电流型PWM控制芯片、实现输出电压可调的开关稳压电源电路。本设计的设计指标参数是交流输入电压185-240V，输出直流电压24V，最大输出电流为1.3A，效率大于75%，具有过流保护作用，且要符合LED的电流电压特性，避免电源对LED使用寿命的影响。本人设计过程中结合自己所学过的内容，请教了好几位同学，和参考了大量网上资料，最后完成了本设计，最后也顺利焊接电路板出来，可由于经验不足，电路不够稳定，容易出现烧坏的现象，经多次做板也难以避免以上情况。 关键词：UC3842、开关电源、PWM? Abstract This article describes a kind of switching power supply which according to cybernetics core UC3842, on the basis of UC3842’s application chapacter, designing a based on the current mode PWM control chip and can adjust to the output voltage. This article describes a kind of switching power supply which according to cybernetics core UC3842, on the basis of UC3842’s application chapacter, designing a based on the current mode PWM control chip and can adjust to the output voltage. The index parameter of this design is 185~240V AC input, the direct-current output is 24V, the current output is less than 1.3A, the efficiency is greater than 75%. What’s more, it has the protection of over-current, complies with the current voltage characteristic of LED and can void power affect the service life of the LED. I according to the content of the learned in the design process, consulted with several classmates, and refer to a large amount of online information. Finally I finished the design and also welding circuit board out smoothly. However, duing to the inadequate experience, the circuit is not stable, and easily burn out. By repeated do plate also hard to avoid the above situation. Keywords: UC3842, Switching power supply, PWM 目录 1 绪论 1 1.1 研究背景 1 1.2 课题研究的目的意义 3 1.3 设计指标 4 2 LED照明对电源的要求 5 3 LED供电电源介绍 7 3.1线性稳压电源 7 3.2开关电源 9 3.2.1开关电源分类 9 4 开关电源设计 10 4.1 电源总体电路 10 4.2 电源芯片 10 4.3 反馈电路