20立方冷干机.docVIP

A. Explanation of Instrument Control Panel 一.仪表板说明 1.Low pressure gauge of refrigerant: It indicates the saturated pressure of refrigerant inside of the evaporator. 冷媒低压表：指示蒸发器内冷媒的饱和压力值. 2-High pressure gauge of refrigerant:It displays the condensing pressure of refrigerant. 冷媒高压表：指示冷媒的冷凝压力值. 3-Air Pressure Gauge:It indicates the pressure of compressed air at outlet of the dryer. 3-空气压力表：指示压缩空气在干燥机出口处的压力值. 4-Monitor:It will display the running status and the parameters setting. 4-显示器：显示设备运行状态及运行参数的设置. 5-Remote/Local switch button:Used for the switch between local and remote control 5-远程/就地转换开关：用于远程/就地控制之间的转换。 6- Start: this button is pressed ,this unit will start running. 6-启动按钮：按启动按钮可启动设备。 7- Stop: By pressing this button, the unit running may be stopped,or assuming that the unit was in trouble,the running can be stopped.Waiting the trouble is settled,pressing this button may reposite the running. (By pressing start button,this unit can be started). 7-停止按钮：按下此按钮可以停止设备，或设备的发生故障后停止运行，等故障排除后按停止按钮复位，（按启动按钮才能启动设备） 8-Power lamp:It is light denotes that power is put through. 8-电源指示灯：此灯亮则表示电源已接通. 9-Start up awaiting: 5 minutes after normal running stop,the lamp will be on which denotes the worker may press the start up botton to start the unit. 9-待启动指示灯：表示正常停机后过五分钟后此灯亮，可以按启动按钮启动设备。 10- Running indication:It is on means that this unit is working 10-运行指示灯：此灯亮表示设备正在运行. 11-Current trouble indication:It is on shows that heat overload relay has accomplished protective function .After removing the trouble,to press the reposition botton to reposite inside PLC programme.This unit may be started by pressing the start up button. 11 -电流故障指示灯 :制冷压缩机过载热继电器起保护，故障排除后按停止按钮复位控制器（PLC）内部程序，按启动按钮才能启动设备。 12-Refrigerant pressure trouble lamp:It is on indicates that the pressure is lower or higher than the demanded and the unit will stop running. Then it is necessary to check this unit and remove trouble. After that press the STOP botton to reposite inside PLC programme.This unit may not be s