金力电机修造厂供电电系统毕业设计论文总结.docVIP

金力电机修造厂供电系统设计 摘要：本论文主要依照工厂供电设计必须遵循的一般原则、基本内容和设计流程，对某电机修造厂变电所进行了设计说明，本文按照设计要求，在查阅大量参考资料、手册后，对负荷计算及无功功率补偿计算，变配电所所址和型式的选择，变电所主变压器台数、容量及类型的选择，变配电所主结线方案的设计，短路电流的计算，变配电所一次设备的选择，变配电所二次回路方案的选择及继电保护装置的选择与整定，变配电所防雷保护与接地装置的设计等进行了详细的设计说明。并附有相应的图表、公式和计算结果。这次设计的变配电所完全满足设计要求。本设计通过对计算负荷，选出变压器；通过计算三相短路电流，选出其他保护器件；通过三相短路电流，选择过电流保护设备；然后选择二次回路的设备，对一次侧设备进行控制、检测；最后注意安全、接地和防雷有功功率电力变压器三相短路电流过电流接地 Jin li motor plants power supply system design ABSTRACT：This thesis mainly according to the factory power supply design must follow the general principles, basic content and the design process, and has carried on the design to a motor plants substation, this paper according to the design requirements, after consult a largenumber of references, manuals, the load calculation and reactive power compensation calculation, distribution of the site and type selection, main transformer substation sets, capacity and type choice, as a main connection scheme of power distribution design, short-circuit current calculation, the choice of distribution by a device, the distribution of the secondary loop scheme selection and the choice of relay protection device and setting, distribution of the lightning protection and grounding device design and so on has carried on the detailed design specifications. With the results and corresponding charts, formulas. The design of the distribution of fully meet the design requirements. This design based on the computational load, select the transformer; Through the three-phase short-circuit current calculation, choose the other protective devices; Through the three-phase short-circuit current, choice over current protection devices; Then select the secondary loop of equipment, to control a side equipment, testing; Finally pay attention to safety, grounding and lightning protection Settings. KEY WORDS: active power； power transformer； three-phase short-circuit current； over current； grounding  目 录 第一章 绪 论 5 1.1 课题背景、目的及意义 5 1.1.1 课题的背景 5 1.1.2 课题的目的及意义 5 1.2 设计的主要内容、设计图样