LIPS电源供应架构分析和设计趋势.ppt

07.04.04 LIPS 電源供應架構分析與設計趨勢 Agenda Agenda Traditional LCD TV Block Diagram Open Frame SMPS Solutions by Size/ Power Level Up to 21” Flyback SMPS 70 W open frame, wide mains input (90 - 264 Vrms), no PFC or dedicated standby Quasi-Resonant (QR) Flyback mode or Standard Flyback is the preferred solution: Inverter and Audio ( 12 Vdc up to 6 A) System power and Standby ( 5 Vdc up to 3 A) Standby requirements: 0.3 W Max for 264 Vrms without load 1 W Max for 264 Vrms with 0.5 W output Up to 21” with Dual Output Flyback SMPS SMPS for Medium Size 26” and 32” Wide range mains input (90 - 264 Vrms) 180 W Max with front end PFC, it operating in CRM (Critical Conduction Mode), switched off in standby 1 single main Flyback SMPS with 2 output voltages: Backlighting power (120 W - 24 Vdc at 4-6 A) Signal processing (12 W - 12 Vdc at 1 A) Audio amplifiers up to 8 Wrms (18 W - 12 Vdc at 1.5 A) Completely OFF in standby 1 dedicated standby SMPS: Single 5 Vdc for both Stand-by and ON Up to 4 A to supply all Signal processing 26” and 32” with Flyback Inverter SMPS SMPS for Medium Size 26” and 32” Main SMPS is a single switch QR Flyback solution Cross regulation may be a concern due to digital dimming of backlight Active Shunt between 12 Vdc and 24 Vdc can control this issue Up to 20 W auxiliary / stand-by SMPS for signal processing based on variable frequency PFM (FOT) controller to achieve low standby Provides bias to PFC and main SMPS, reducing standby consumption In standby, N-MOS power switch disconnects unnecessary 5 Vdc-ON loads (must be capable to handle all safety and short circuits tests) Given 20 W capability, it is easy to achieve 1 W in standby with reduce output power SMPS for Medium Size 32” and 37” Wide range mains input (90 - 264 Vrms) Same architecture as 26” - 32” with new HB LLC due to the increased Power for Inverter Up to 220 W with front end PFC. It also be operating in CRM (Critical Conduction Mode), switched off in standby 1 single