供电工程课程设计剖析.docVIP

湖北理工学院 电气与电子信息工程学院 供配电工程课程设计报告 设计题目：某重型设备制造公司重型设备制造公司 要求根据用户所能取得的电源及本厂用电负荷的实际情况，并适当考虑到工厂生产的发展，按照安全可靠、技术先进、经济合理的要求，确定变电所的位置与型式，确定变电所主变压器的台数与容量、类型，选择变电所主接线方案及高低压设备和进出线，最后按要求写出设计说明书，绘出设计图样。 三、设计依据 1、工厂负荷情况 该公司以生产冶金、建材、电站、化工制粉、破碎设备及备件为主业，产品有MPS、LM型中速磨、水泥磨、圆锥破碎机、颚式破碎机、钢球磨、单齿辊破碎机及备件，同时公司还生产高铬铸造合金系列、镍硬铸造合金系列、各种高合金钢铸件。公司下设铸钢车间、铸铁车间、精整车间、机加车间以及科研办公楼。表1负荷统计资料 编号 厂房名称 设备容量/kW 需要系数 功率因数 1 铸钢车间铸铁车间精整车间机加车间科研办公楼Abstract This paper mainly for small factory electric part of power distribution system design, the factory introduced by outdoor 10 kv high voltage power supply, after reduced to 220/380 of the low-voltage electrical substation, the total direct to factory workshop of power systems and lighting. Before selection of electrical equipment to the factory to load calculation, determine the total load capacity of the factory, reactive power compensation in low voltage bus bar at the same time, in order to improve power factor. According to the compensation of load capacity, choose the factory substation transformer capacity and the Numbers. And then determine the factory power supply system, select the appropriate workshop power distribution scheme, draw the wiring diagram of power supply and distribution system. High side one equipment, low voltage devices and wire cross-sectional area when the choice, must meet the normal circuit conditions and work under short circuit fault. Electrical equipment should not only meet the requirements under the short circuit fault of factory. Also must be the biggest failure of dynamic stability and thermal stability check, to determine equipment whether meet the job requirements. Circuit of three phase short circuit occurs the maximum short-circuit current, three-phase short-circuit current calculation, to check of the equipment. Finally carries on the relay protection and lightning protection grounding to improve safety and reliability of the system. Keywords: load calculation, the main three phase short circuit, wiring, relay prote