RT-Thread的RT-GUI在神舟开发板上移植.docVIP

RT-Thread的RTGUI移植步骤 （1.10RC版本） 一.写好液晶屏幕的 画点ssd1289_lcd_set_pixel, 获得点ssd1289_lcd_get_pixel, 画横线 ssd1289_lcd_draw_hline,// 画竖线ssd1289_lcd_draw_vline, 原始水平线ssd1289_lcd_draw_raw_hline 以上函数的参数要参考rtgui_graphic_driver_ops结构体 液晶初始化函数ili9320_Initializtion(); 六个底层驱动函数 二.准备好三个结构体 1.结构体原型 struct rtgui_graphic_driver_ops { /* set and get pixel in (x, y) */ void (*set_pixel) (rtgui_color_t *c, int x, int y); void (*get_pixel) (rtgui_color_t *c, int x, int y); void (*draw_hline)(rtgui_color_t *c, int x1, int x2, int y); void (*draw_vline)(rtgui_color_t *c, int x , int y1, int y2); /* draw raw hline */ void (*draw_raw_hline)(rt_uint8_t *pixels, int x1, int x2, int y); }; 结构体使用例子 struct rt_device_graphic_ops lcd_ili_ops = //图形驱动接口 { ssd1289_lcd_set_pixel, //画点自己实现 ssd1289_lcd_get_pixel, //获得点 自己实现 ssd1289_lcd_draw_hline,//画横线 自己实现 ssd1289_lcd_draw_vline, //画竖线 自己实现 ssd1289_lcd_draw_raw_hline //原始水平线 自己实现 }; 2.结构体原型 struct rt_device { struct rt_object parent; /** inherit from rt_object */ enum rt_device_class_type type; /** device type */ rt_uint16_t flag; /** device flag */ rt_uint16_t open_flag; /** device open flag */ rt_uint8_t device_id; /** 0 - 255 */ /* device call back */ rt_err_t (*rx_indicate)(rt_device_t dev, rt_size_t size); rt_err_t (*tx_complete)(rt_device_t dev, void *buffer); /* common device interface */ rt_err_t (*init) (rt_device_t dev); rt_err_t (*open) (rt_device_t dev, rt_uint16_t oflag); rt_err_t (*close) (rt_device_t dev); rt_size_t (*read) (rt_device_t dev, rt_off_t pos, void *buffer, rt_size_t size); rt_size_t (*write) (rt_device_t dev, rt_off_t pos, const void *buffer, rt_size_t size); rt_err_t (*control)(rt_device_t dev, rt_uint8_t cmd, void *a