1250HC轧机主传动设计.docVIP

1250HC轧机主传动设计 摘 要 本次设计为hc轧机主传动结构。轧钢机主传动系统主要由电机、齿轮座、联轴器及机架组成。本次设计是对hc轧机进行主传动系统设计，包括电动机、联轴器及机架，通过计算轧制力能参数并进行零件强度校核分析来完成设计内容。使设计方案能够达到使用要求，并且合理可行，然后进行轧制力能参数的计算，并根据算出的结果来选择电动机并进行校核、计算，同时对其中的主要零部件，如轧辊、连接轴、传动轴、等进行强度计算，保证了使用的安全性与可靠性，最后对润滑方式进行了简单分析，对经济性也进行了分析。 关键词：轧机；轧辊； The Design Of The Main Driver Of 1250 HC Mill Abstract This design to the hc mill main drive structure. Main drive system of steel rolling is mainly composed of motor,shaft coupling and frame. This design is carried out on the hc mill main drive system design, including motor.coupling and frame, through the calculation of rolling force can parameter and intensity analysis of the parts to complete the design content. So that the use of design to meet requirements and is reasonably practicable. and then rolling force can be calculated parameters,and in accordance with the results calculated to select the motor and check the calculation, while the main components, such as roller, connecting shaft. transmission shaft and tooth strength and wear resistance of the check to ensure that the use of the safety and reliability, the last of the Lubrication Analysis of a simple manner, on the economy is also analyzed.Considering the cost problem, motor with low cost high speed of ac motor. In the process of design, we should consider the practicality manufacturing difficulty. Economic factors and problems encountered in the actual production. Gear stand: used to transfer torque to work roll. the design USES two equal diameter cylidrical herringbone gear in the vertical plane in a row. packed in the sealed enclosure. Coupling: the gear reducer and connecting shaft of a secure connection. The main motor with plum blossom joint shaft coupling in general. Keywords：rolling mill; roll;The Main Driver；Electric；Roller 目 录 1. 绪论 1 1.1选题背景和目的 1 1.2国内外发展情况 1 1.3课题研究的主要内容 3 2. 总体方案设计 4 2.1轧钢机主传动装置的类型 4 2.1.1 单机座轧钢机 4 2.1.2 多机座轧钢机主传动类型 4 2.2方案对比与选择 4 2.3各零部件类型选择的确定 5 2.3.1 电机 5 2.3