主板电源不能接通的诊断.docVIP

主板电源不能接通的诊断 电源开关与机床开关后，电源不能接通 After the power switch and switch machine, power supply cant get through 　(1)电源输入端熔断器熔芯熔断或爆断(或自动开关跳闸)。 (1) the power input fuse fusing or molten core fault (or automatic switch trip). 　　(2)机床电源进线断。 (2) the machine power supply into line. 　　(3)机床总电源开关或电源开关坏。 (3) the machine total power switch or power switch is bad. 　　(4)电气控制柜门未关好，开门断电保护开关动作。 (4) electrical control cupboard door is not closed, the door switch power-off protection action. 　　(5)电气控制柜上的开门断电保护开关损坏或关门后与碰块接触不良。 (5) electric control cabinet to open the door after power-off protection switch damaged or shut down and touch a poor contact. 当电源单元不能接通时，如果电源指示灯(绿色)不亮 When the power supply unit does not switch on, if the power indicator (green) is not on 　　(1)电源单元的保险熔断输入高电压，元器件损坏，造成短路或过流。 (1) safety fuse type high voltage power supply unit, component damage and cause short circuit or over current. 　　(2)输入电压低，检查输入电压，电压的允许值为ac200v±10％，50hz±1hz。 (2) the low input voltage, check the input voltage, the voltage of the allowable values for ac200v plus or minus 10%, 50 hz + 1 hz. 　　(3)电源单元不良，元器件损坏。 (3) power supply unit is bad, the damage of components. 　　 电源指示等亮，报警灯也消失，但电源不能接通 Power supply instructions such as light, alarm lamp also disappear, but cannot plug in 　　电源接通条件如下： The power on condition is as follows: 　　(1)电源on按钮闭合。 (1) the power on button closure. 　　(2)电源off按钮闭合。 (2) the power off button closure. 　　(3)外部报警接点打开。 (3) open the external alarm contacts. 当电源单元不能接通时，如果电源指示灯(绿色)不亮 When the power supply unit does not switch on, if the power indicator (green) is not on 　　(1)电源单元的保险熔断：输入高电压，元器件损坏，造成短路或过流。 (1) power supply unit safety fuse: input high voltage components damaged, causing a short circuit or over current. 　　(2)输入电压低：检查输入电压，电压的允许值为ac200v±10％，50hz±1hz。 (2) the low input voltage: check the input voltage, the voltage of the allowable values for ac200v plus or minus 10%, 50 hz + 1 hz. 　　(3)电源单元不良，元器件损坏。 (3) power supply unit is bad, the damage of components. 　　 电源指