ROUTE Chater 1 6.0 .docVIP

ROUTE Chapter 1 CCNP 6.0 2012 100% 1. Which route description best defines a floating static route?a route with a metric equal to the metric of a corresponding dynamic routea route with a metric less than the metric of a corresponding dynamic routea route with a metric greater than the metric of a corresponding dynamic routea route with an administrative distance less than the administrative distance of a corresponding dynamic routea route with an administrative distance greater than the administrative distance of a corresponding dynamic route 2. The OSPF routing protocol is enabled on a network. The administrator would like to enable a floating static route to be used as a backup. Which is the correct setting for the administrative distance of the floating static route?0150100120 3. The following line was displayed in the output of the show ip route command:192.168.3.0/24 [120/2] via 192.168.2.2, 00:00:30, Serial0/0Which routing protocol is the source for this route?BGPEIGRPODROSPFRIP 4. What is the administrative distance of EIGRP-learned routes that have been injected into EIGRP via redistribution?190100110170180 5. For ODR learned routes, what is the default administrative distance and metric that is displayed by the show ip route command?[160/0][160/1][170/0][170/1] 6. Which type of traffic should receive the highest level of priority by QoS mechanisms in a converged network design?real-time traffictransactional trafficrouting protocol trafficnetwork management traffic 7. In a converged network, which two types of traffic would be categorized as real-time traffic? (Choose two.)e-mailfile transferweb browsingvideoconferencingvoice over IP 8. What is the role of QoS in a converged network?to ensure that real-time traffic is not delayedto give highest priority to transactional trafficto ensure that all traffic above available bandwidth levels is droppedto protect against the impact of worms, viruses, and other network atta