200W-PFC整流电源设计.doc

‘ 200w PFC整流电源设计摘 要 本次设计是采用高功率因数校正集成控制电路芯片UC3854和ZVT（零电压转换）软开关设计200W ZVT-PFC整流电源。 设计采用升压电路构成ZVT-PFC整流电源，主电路包括主开关S，二极管D，谐振电感L，谐振电容C等元器件共同构成ZVT电路，其中主开关S工作在零电压条件下开通。 上述主电路具有以下优点： 1.主开关在零压条件下开通，快恢复二极管在零压条件下关断，可降低开关的损耗和开关的噪声。 2.可抑制开关器件关断时所产生的尖峰电压。 3.恒频工作。 4.不需要阻容吸收电路。 5.主开关与辅助开关源极同电位，驱动电路不需隔离，容易实现。 控制电路的设计是使用功率因数校正集成电路UC3854，这是平均电流控制模式，该装置具有一个软启动功能，并具有较高的参考电压和振荡器输出振幅，并且具有改善噪声容限和适用于功率较大场合的应用。 论文首先介绍PFC的工作方式及作用，根据PFC的特点应用到整流模块中，之后介绍电路的整流模块，对主电路和控制电路进行设计和分析，对主电路和控制电路相关物理量进行计算，看其是否符合性能要求。 关键词：PFC 整流电源 功率因数校正 ABSTRACT The use of high power factor correction circuit chip UC3854 integrated control and ZVT (zero voltage switching) soft switch design 200W ZVT-PFC rectifier power. Design uses a boost circuit ZVT-PFC rectifier power supply, the main circuit as shown below where the main switch S, resonant inductor L, the resonant capacitor C, diode D and other components together constitute the ZVT circuit, so that the work of the opening of the main switch at zero voltage conditions. Said main circuit has the following advantages: 1 opening of the main switch zero pressure, fast recovery diodes zero pressure off, can reduce switching losses and switching noise. 2 inhibits switching devices off when the voltage spikes generated. 3. Constant frequency operation. 4 No RC snubber circuits. 5 and the main switch with the source potential of the auxiliary switch, the drive circuit without isolation, is easy to achieve. Power factor correction control circuit uses IC UC3854, which uses average current control mode, the device has a soft start feature and has a high reference voltage amplitude of the oscillator output, improved noise tolerance of the device, suitable for large power occasions. Working paper introduces methods and the role of PFC, the application according to the characteristics of the PFC rectifier module, rectifier circuit after the introduction of the main circuit and control circuit design and analysis, the main circuit and