昌图至调兵山二级路综合设计计算书1.docVIP

摘 要 根据设计任务书提供的设计资料和设计要求以及部颁标准和规范对昌图之调兵山二级公路K0+000～K4+579.918段进行了路基路面综合设计。设计车速为80km/h ，双向车道。，在路上选了个交点，半径m，m, 300m, 370m。纵断面设计全线共设个变坡点，半径分别为米，1000米，米，米, 米。小桥涵设计主要进行了桥梁上部结构的计算和验算。 通过本次毕业设计，在专业知识方面得到了综合训练和提高，增强了独立分析和解决问题的能力，取得了很好的效果。 关键词： 二级公路；路基；路面；综合设计 Abstract According to the technical standards and specifications for highway design published by the Ministry of Communications of China, the comprehensive design of highway subgrade and pavement from K0+000 to K4+579.918has been carried out based on the data of Changtu-Diaobingshan secondary roads in Liaoning Province. The designed vehicle speed is 80km/h , bidirectional two traffic lanes. The main contents of the design included highway line of graphic design, vertical alignment design, line cross-sectional design, subgrade and pavement drainage, pavement structure design, the design of small bridges, construction design, and the preparation of budget estimate, ect. In the plane design, considered is the mountainous terrain area newly built road, I have chosen four points of intersection on the Lines in the design roads, the point of intersection radius respectively is 500m, 600m, 300m, 370m,. In the profile section design, the entire line has six to change the slope spot, the radius respectively is 12500m, 10000m, 3800m, 112100m, 10000m，3400m. The small arch of bridge design has mainly carried on the bridge structure computation and checking computations. Design is a 18 meters of reinforced concrete T-beam bridge. In addition, it has the related content of the construction organization plan and budgets and so on . During this graduation design, the expertise is a comprehensive training, and the ability of independent analysis and solving problems were improved and strengthened, so good effects have been achieved. Key words : Secondary roads；subgrade；pavement；comprehensive design 目 录 第一章 设计资料与任务 1 1.1地质概况 1 1.2 公路运输的情况 1 1.3 沿线自然条件 2 1.4 设计内容 3 第二章 公路平面设计 4 2.1 路线布设 4 2.1.1路线布设原则 4 2.1.2选线 5 2.1.3平原区选线