轴承内外圈加工专用机床上料机构机械CAD图纸设计论文.doc

摘要 关键词：Abstract This article is based on the requirements of the bearings inside and outside circle line renovation project of the wuxi dior machinery, and it aims to solve the problem that the manual feeding by workers which is dangerous for workers, and it has low efficiency, therefore a set of bearing inner and outer circle machining machine tool feeding mechanism is designed to replace the manual feeding of workers, and ensure the security of workers when operating, and improving producing efficiency. This paper provides a reasonable design of the feeding mechanism according to the characteristics of the bearing inner and outer circle. The feeding mechanism mainly achieves the following functions: the automatically positioning, clamping and artifact-play backing of the billet, etc. This series of movement is driven by cylinder. The design part of this design mainly includes: the design portion of feeding mechanism; material design; the design of Clamping mechanism; Drive systems, etc. The method is: firstly determining the dimensions of the feeding mechanism, and then using UG software for parametric modeling of parts of the feeding mechanism, after that, doing virtual assembly to the overall structure; then importing the assembly body to the motion simulation interface of UG software, and using the software to do kinematics simulation and dynamics simulation. Thereafter, analyzing the simulation results, and getting the corresponding conclusions. Finally the optimization design of bearing inner and outer circle machining machine tool feeding mechanism is done, to improve its stability, reliability, and to make the design truly enter into the daily production operation, make it practical and able to contribute to bearing factory production line modification. Key words: feeding agencies; parametric modeling; virtual assembly; motion simulation 目 录 摘要 III Abstract IV 目 录 VI 1 1.1 上料机构设计的研究内容和意义 1 1.2 上料机构国内外发展现状 1 1.3 本课题应达到的要求 2 2 总体方案设计 4 2.1 上料机构