泵站设计关键.pptVIP

Key Factors for PS Design泵站设计关键因素;Installation 安装位置 Inside/outside, on or below the floor, etc.. 室内/室外， 地面/地下等 Size of the installation 安装尺寸 Wastewater, rainwater flow, Head 污废水，雨水的流量、扬程 Material 材料 Concrete, fibre glass, polyethylene, etc 混凝土、玻璃钢或聚乙烯等 Requested equipments 设备要求 Screen, separate valve chamber, level switch, etc. 格栅、独立阀门井、液位开关等 ;;Sizing of wastewater pumping station 污废水泵站尺寸;The depth of the minimum volume must be high enough to avoid the pump sucking air 最小容积高度应该避免水泵吸入空气 Direct fall from the inlet should be minimized to avoid air in the pump 进水管跌水高度最小化，避免水泵吸入空气 Maximum velocity of water intake : 1,2 m/s 最大入流流速1,2 m/s Inclined bottom (45 ° to 60°)（PUST） 底部倾斜(45 ° to 60°)(PUST);Minimum diameter at the bottom （PUST）increases the water velocity and facilitate the pumping of solid matters 底部直径缩小(PUST)增加了水的流速，有利于泵送固体介质 Minimum stop level for SE1/SEV with stainless steel jackets is just above the pump housing 不锈钢外壳的 SE1/SEV的最低停泵液位为水泵涡壳以上 For other pumps: Stop level at least in the middle of the motor 对于其他的水泵：停泵液位最低至电机的中部;It is very important to get the distance between start and stop right. 启/停液位之间的距离非常重要 The start level and stop level must be as close as possible to 启停液位应尽可能满足 design the tank size by optimizing the effective volume 优化有效容积,设计井筒尺寸;It is very important to get the distance between start and stop right. 启/停液位之间的距离非常重要 The start level and stop level must be as close as possible to 启停液位应尽可能满足 design the tank size by optimizing the effective volume 通过优化有效容积设计井筒尺寸;The start level and stop level must be as close as possible to 启停液位的距离应尽可能小，从而 shorten the stay time of the wastewater 缩短废水停留时间 Reduce the performance variation Q, H and η 减少 Q, H and η的变化;2 - Effective Volume有效容积;T = Pumping cycle period 水泵运行周期 Ts = Stopping period 停泵周期 Tp = Pumping period 泵送周期 T=Tp+Ts;Qww/Qp;2 – Calculating the effective volume – theory有效容积计算－原理;Monogram for the determination of the accumulated volume between start and sto