《Design, Modeling, and Analysis of a Compact Planar Transformer》.pptVIP

;1 INTRODUCTION 2 COMPACT PLANAR TRANSFORMER DESIGN 3 MODELING OF THE TRANSFORMER 4 DISCUSION 5 CONCLUSION;This paper presents a new design of a planar transformer. Over the surface of a ?at core, meander-type design was engraved, so that symmetrically adjusted primary and secondary coils, of the same meander-type, can ?t into the engraved design. Primary and secondary coils were covered with another ?at core consequently forming a compact planar transformer. Windings of primary and secondary coils are printed on both sides of PCB. Conductive stripes of a winding from upper and bottom layer ar