产万吨棒材生产车间设计重点.docVIP

学 号： HEBEI UNITED UNIVERSITY 毕业设计说明书 GRADUATE DESIGN 设计题目：年产60万吨棒材生产车间设计 学生姓名： 专业班级： 学 院： 冶金与能源 指导教师： 2012年5月31日摘 要 设计年产量60万吨的小型棒材厂，品种为Ф14～40mm的圆钢和螺纹钢，典型产品为Ф12的螺纹钢。 棒材以定尺交货，横列式、半连续式、全连续式各种轧机都可以进行生产。平立交替的连轧棒材事故少，生产效率高，产量大，因而棒材生产普遍向连轧发展。本设计任务为年产60万吨，可以采用半连续式或全连续式，考虑减少事故，为将来扩大产能，本设计采用全连轧方式 本车间设计的主要依据是现代棒材生产工艺过程的理论，参阅了国内有关棒材轧机的先进工艺、轧机的装备、技术、孔型系统及一些辅助设备的论述，重点参照唐银棒材厂和石钢棒材厂, 采用全连轧方式,而设计了此车间。 此设计说明书以设计任务书出发，论述了建厂的必要性和可能性，并按照车间设计的步骤进行设计，主要包括：产品大纲的制定、轧机的选择、孔型系统的选择及典型产品的孔型设计、力能参数的计算及校核、辅助设备的选取等。 附有孔型图及车间平面图，以便参考。 关键词：连轧棒材；高刚度轧机；平立交替轧机；高精度圆钢 ABSTRACT Annual capacity of 700,000 tons, the variety is round and rebar small bar in the factory, its specifications were Ф14 ~ 40mm round steel and steel, select Ф12 of rebar as a typical product of the workshop design at this time. The main basis of this design of workshop is a theory of the production technology course of modern excellent material, have consulted the domestic equipment, technology, pass system and argumentation of some auxiliary equipment about the advanced craft of the rolling mill of excellent material, rolling mill, consult and bear the steel excellent material factory, has fetched some technical parameters and designed this workshop . This design instruction set out with design specifications, has described necessity and possibility of founding the factory at first, then design according to the step of the design of workshop , it is mainly the formulation of the products outline, choice , choice and typical pass design of products , pass of system of rolling mill,, strength can calculation , check and auxiliary equipment of parameter choose etc.. In addition, this text encloses the rolling chart , pass picture and workshop plane figure, in order to consult. Keywords: tandem rolling steel bar；stiff mill；isscross alternately mill；high degree of accuracy round steel 目 录 摘 要 I ABSTRACT II 引 言 1 1 文献综述 2 1.1 棒材产品的种类、用途和质量要求 2 1.2 棒材轧制技术的研究进展 2 1.2.1 连铸坯热装热送或连铸直接轧制 2 1.2.2 柔性轧制技术 3 1.2.3 高精度轧制 3 1.2.4 轧制速度进