公司规格书模版。.docVIP

环盛电子有限公司 HUAN SHENG ELECTRONICS CO.,LTD 规 格 书 SPECIFICATION 编号N o. KCD 日期DATE 2012/9/5 1.概述 GENERAL 2.外观与尺寸 APPEARANCE AND DIMENSIONS 2.1外观 APPEARANCE : 无影响产品使用性能的缺陷. There shall be no derfects that effect the serviceability of the product. 2.2标识 MARKING: 应有商标、型号、额定值、认证标志等标识. There shall be trademark, module No, rating, license mark and other necessary mark on the switch body. 2.3尺寸 DIMENSIONS: 应符合产品图. Shall conform to drawing. 3.性能要求: PERFORMANCE 项目 ITEM 测试条件 TEST CONDITIONS 要求 REQUIREMENT 3.1电气性能 ELETRICAL PERFORMANCE: 3.1.1 接触电阻 CONTACT RESISTANCE 开关处于闭合状态,用微电阻测试仪或高精度线性毫欧计测量端子间的电阻. The switch to be made in“on” state, and the resistance be measured between the two terminals with micro-resistance test instrument or high precision liner mro-ohm meter. 50mΩ max 3.1.2 绝缘电阻 INSULATION RESISTANCE 触点间的绝缘和功能绝缘: 约500伏的直流电压施加在处于断开状态的开关的两触点间和开关的不同极之间,相同极性的导电 CONTACT AND OPERATIONAL INSULATION: A d.c. voltage of approximately 500V is applied between the open contacts of each pole of a switch and between the different poles of which all the parts is connected together, the measurement shall be mabe after the voltage is applied for 1 min. 10MΩ min 加强绝缘:约500伏的直流电压施加在导电部件和覆在易接触的开关外表面的金属箔及易接触的金属后进行测量. REINFORED INSULATION: A d.c. voltage of approximately 500V is applied between all live parts and a metal foil covering the outer accessible surface and accessible metal parts , the measurement shall be made after the voltage is applied for 1 min. 100MΩ min 3.1.3 介电强度 DIELECTRIC STRENGTH 触点间和各极间的介电强度: 处于断开状态的开关的两触点间和开关的不同极之间,应能承受基本为正弦波形,频率为50或60赫 AND BETWEEN DIFFERENT POLES: 无击穿或闪络现象 No flashover or breaskdown shall occur 共 5