wellplan--水力参数计算.pptxVIP

WELLPLAN Hydraulic AnalysisContents1、Topics Discussed in the Module2、Analysis process3、Introduction and Concepts4、Navigating Hydraulics Module5、ExercisesTopics Discussed in the ModuleStudy cases too complex for hand calculations“what if” analysis is made easyOptimize flow rates based on:bit performance (maximize ROP)hole cleaningStudy ECD’s with regard to limitations of:pore pressure（孔隙压力）fracture pressure（破裂压力）Avoid kicks（井涌） and formation damage resulting from swab and surge pressuresObjectives Explain the purpose of the Hydraulics module(模块).State when the Hydraulics module should be used.Explain the different modes of Hydraulics analysis. Explain the use of Hydraulics module for practical applicationOverviewHole cleaning model is based on empirical relationships coupled with analytical formulationsBasis for frictional pressure loss calculations using Rheological models （流变模型）such as Bingham Plastic, Power Law（幂律）, Newtonian, Herschel-Bulkley, and Generalized Herschel-Bulkley.Swab/Surge calculations based on conventional steady-state model（稳定模型）. Effect of wellbore circulating temperatures on fluid properties are based on transient models.Pipe roughness and eccentricity calculations for Herschel-Bulkley are based on empirical correlations. Pressure drops across mud motors, MWD’s, split flow（分流） components such as under reamers and hole openers are accounted.Analysis processDrillingReview Data Mode: Hole Cleaning Operational View PlotsProvideSolution-Best Pump- Min QSensitivityRPMROPProblemOKPump Rate Range Mode（压力损失，环空流速，环空排量）PumpLimitations.ProblemSelect New PumpOKCheck Critical AnnulusVelocity and Q ModeCont. on next slideAnalysis processMode:Pressure: Pump Rate FixedRate DialogViewPieCharts.ViewPlotsViewQuickLook.OKOKOKOptimize PlanningImpact ForceHHPOKOKOptimize Nozzle CheckFinal CheckHole Cleaning- Pressure Loss- ECD ChartsSign OffWhen Should I Use Hydraulics ModulePressure LossAnnular VelocitySwab/Surge Hydraulics OptimizationHole CleaningIntroduction and