測試條件.pptVIP

電源測試 Inrush Current 開機瞬間電流 Purpose: Measure the inrush current of the input while the power supply turn on. 目 的:量測輸入電源電壓瞬間開啟時，電源供應器之瞬間開機電流. Environmental Conditions: Temperature 25℃, Relative Humidity 65% 環境條件: 溫度25℃ 相對濕度65% Test Conditions: 1.The input voltage frequency must be under any condition in the range of the product specification 測試條件: 1.輸入電壓以產品規格之全電壓頻率範圍 Min/115Vac/230Vac/Max 2. The output load is full load on all outputs at under the product specification. 2. 輸出負載以產品規格之最大額定電流值﹒ 3. The measurement can be implemented only when the AC input voltage at the phase of 90 °and then the power supply turn on. 3. 量測時必須於輸入之交流電壓在相角90°時，將電源供應器開啟，量測其輸出入瞬間 電流量﹒ 4. Do the test in cold start one time, so do in hot start one time. 4. 冷機和熱機各做一次. Result limit: Sure there is no damage of components. 結果判定:不能造成產品元件損坏. Test Waveform 1.Input Current Power 輸入電流及功率 Purpose: Measure the input current and power of the switch power supply. 目 的:量測電源供應器之輸入電流及功率 Environmental Conditions: Temperature 25℃, Relative Humidity 65% 環境條件:溫度 25℃，相對濕度65% Test Conditions: 1.The input voltage frequency must be under any condition of the range of the product specification. 測試條件:1.輸入電壓及頻率以產品規格之全電壓頻率範圍 2. The output load is full load on all outputs 2.輸出負載以產品規格之最大額定電流值 Full Load = Result limit: The maximum input current shall not exceed the specified. 結果判定:輸入電流不能超出產品規格 Efficiency And Power Factor輸出效率及功率因素 Purpose: Measure the efficiency and power factor of the SPS. 目 的:量測電源供應器之輸出效率及功率因素 Environmental Conditions: Temperature 25℃, Relative Humidity 65% 環境條件 : 溫度25℃ 相對濕度65% Test Conditions: 1.The power supply must be on for 10 minutes before measure. 測 試 條 件: 1.需先開機10分鐘 2. The input voltage frequency must be under any condition in the range of the product specification. 2. 輸入電壓及頻率以產品規格之全電壓頻率範圍 3. The output load is full load on all outputs . 3. 輸出負載以產品規格之最大額定電流值 Result limit: The efficiency must exceed the specified. 結果判定: 效率必須大于產品規格才合格. Energy Star(B